| auszookers.com http://auszookers.com/forum/ |
|
| Jimmy airlocker tube http://auszookers.com/forum/viewtopic.php?f=5&t=29686 |
Page 1 of 1 |
| Author: | zooky08 [ Wed Jan 18, 2012 6:06 am ] |
| Post subject: | Jimmy airlocker tube |
Went to put my locker in my Jimny and I have discovered a problem I can't seem get the diff center in because the copper tube is in the way. The Jimny front diff housing is a stupid design. They give you no clearance at all, I have 1mm of clearance right around the center to play with. There are slots in the bolting ring that alouds the crown wheel to go through. So only one way it will go it. Here is a pic, sorry it's bad qaulity not much light. Tube in the way 
Slot in bolting ring 
|
|
| Author: | 31zook [ Wed Jan 18, 2012 8:06 am ] |
| Post subject: | Re: Jimmy airlocker tube |
Can you push the brass tube more towards the front? So it kinda goes infirst? And how much was your locker? |
|
| Author: | zooky08 [ Wed Jan 18, 2012 8:23 am ] |
| Post subject: | Re: Jimmy airlocker tube |
That's what I did but it's awfully close to the crown wheel now. Hope it doesn't come in contact with the crown wheel, that would be bad $1126  rear one was cheaper
|
|
| Author: | 31zook [ Wed Jan 18, 2012 8:37 am ] |
| Post subject: | Re: Jimmy airlocker tube |
bugger, i have no idea...... if i was very very shep, i would grind the tiniest bit out of the housing to slide the tube through.... |
|
| Author: | smiffkid [ Wed Jan 18, 2012 8:42 am ] |
| Post subject: | Re: Jimmy airlocker tube |
when we did ours it didn go over the crown wheel but it hit on the housing at the front which peirced the copper had to ground the housing center out enough to let the copper fit with enough movement works a treat now |
|
| Author: | zooky08 [ Wed Jan 18, 2012 8:50 am ] |
| Post subject: | Re: Jimmy airlocker tube |
It's all bolted in now I just reshaped it around the front of the crown wheel and it went straight in. |
|
| Author: | smiffkid [ Wed Jan 18, 2012 8:51 am ] |
| Post subject: | Re: Jimmy airlocker tube |
does it work proper |
|
| Author: | zooky08 [ Wed Jan 18, 2012 9:05 am ] |
| Post subject: | Re: Jimmy airlocker tube |
You mean does the locker work not sure everything isn't back together yet |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|