does anyone know if a 1.3 gti head will fit a 1.6 carby motor??
if yes, what would be required to make it work?
if no, shiiiiitttt
| auszookers.com http://auszookers.com/forum/ |
|
| 1.3 gti head, 1.6 carby motor http://auszookers.com/forum/viewtopic.php?f=5&t=30807 |
Page 1 of 1 |
| Author: | bek [ Tue Feb 28, 2012 5:46 pm ] |
| Post subject: | 1.3 gti head, 1.6 carby motor |
does anyone know if a 1.3 gti head will fit a 1.6 carby motor?? if yes, what would be required to make it work? if no, shiiiiitttt
|
|
| Author: | jonno_racing [ Tue Feb 28, 2012 5:52 pm ] |
| Post subject: | Re: 1.3 gti head, 1.6 carby motor |
no. u need fly cut pistons. (g16b) one that is sorted u will have a low compresion last motor. |
|
| Author: | Fatzook [ Tue Feb 28, 2012 5:53 pm ] |
| Post subject: | Re: 1.3 gti head, 1.6 carby motor |
The GTi is a 16 valve motor. The 1.6 carby is an 8 valve motor. At the very least you would need to fit G16B 16v pistons, as they have an extra relief cut into the top of the piston to clear the extra valves. So short answer is, no.....not without mods. |
|
| Author: | bek [ Tue Feb 28, 2012 5:57 pm ] |
| Post subject: | Re: 1.3 gti head, 1.6 carby motor |
dang okay thanks guys
|
|
| Author: | jonno_racing [ Tue Feb 28, 2012 6:00 pm ] |
| Post subject: | Re: 1.3 gti head, 1.6 carby motor |
I have looked in2 gti/1600 a few times, more work than its worth. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|