auszookers.com
http://auszookers.com/forum/

Rear hub bolts
http://auszookers.com/forum/viewtopic.php?f=5&t=3095		 Page 1 of 1
Author:  Damo [ Sun Oct 05, 2008 8:59 pm ]
Post subject:  Rear hub bolts
What size are the bolts that hold drum on to the axle shaft? M12?
Author:  royce [ Sun Oct 05, 2008 9:24 pm ]
Post subject:  Re: Rear hub bolts
the thread IIRC is M12 FINE

the studs in the axle, no idea how long they are but at a guess 35mm?
Author:  Damo [ Sun Oct 05, 2008 9:28 pm ]
Post subject:  Re: Rear hub bolts
royce wrote:
the thread IIRC is M12 FINE

the studs in the axle, no idea how long they are but at a guess 35mm?


Yeah they would be about that. Has anyone had the nuts on these fail before? Prolly just idiots doing them up too right i'd say.
Author:  TZAR [ Sun Oct 05, 2008 9:44 pm ]
Post subject:  Re: Rear hub bolts
Damo wrote:
royce wrote:
the thread IIRC is M12 FINE

the studs in the axle, no idea how long they are but at a guess 35mm?


Yeah they would be about that. Has anyone had the nuts on these fail before? Prolly just idiots doing them up too "right" i'd say.


I have destroyed heaps of these nuts

Fine threads and rattle guns don't mix
Author:  Damo [ Sun Oct 05, 2008 9:48 pm ]
Post subject:  Re: Rear hub bolts
TZAR wrote:
Damo wrote:
royce wrote:
the thread IIRC is M12 FINE

the studs in the axle, no idea how long they are but at a guess 35mm?


Yeah they would be about that. Has anyone had the nuts on these fail before? Prolly just idiots doing them up too "right" i'd say.


I have destroyed heaps of these nuts

Fine threads and rattle guns don't mix


Rattle guns are OK, it's usually the ape on the trigger that's the problem!!! Present company excepted of course :P

I think i'll replace them with some course thread high tensile bolts.
Author:  royce [ Sun Oct 05, 2008 9:51 pm ]
Post subject:  Re: Rear hub bolts
ive had plenty of nuts die, I think they are just too thin and they wear over time like all fasteners

jsut get some generic nylocs, they fit fine and are a lot fatter, you could also turn wheel nuts around :wink:
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/