| auszookers.com http://auszookers.com/forum/ |
|
| Why use 1.3 head on the 1.6 block? http://auszookers.com/forum/viewtopic.php?f=5&t=30992 |
Page 1 of 1 |
| Author: | red diggity [ Wed Mar 07, 2012 6:42 am ] |
| Post subject: | Why use 1.3 head on the 1.6 block? |
I have been thinking about doin the swap putting my 1.3 head with webber carby on to a 1.6 block this should be quite good for higher Rev's but not low down torque would I be right in saying??? |
|
| Author: | jdk81 [ Wed Mar 07, 2012 6:45 am ] |
| Post subject: | Re: Why use 1.3 head on the 1.6 block? |
Vice versa. I dont have a weber, but I rejetted the 1.3 carby. I have found down low the torque is really really good, at high rpm theres not much difference (the 1.3 head is too restrictive at high air flow). EDIT: I did it because it was cheap, and easy. |
|
| Author: | red diggity [ Wed Mar 07, 2012 7:11 am ] |
| Post subject: | Re: Why use 1.3 head on the 1.6 block? |
Ok yer makes sence might just. Hold up the 1.6 head then |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|