| auszookers.com http://auszookers.com/forum/ |
|
| g13a wont idle after head gasket change. http://auszookers.com/forum/viewtopic.php?f=5&t=31088 |
Page 1 of 1 |
| Author: | HellonWheels [ Sun Mar 11, 2012 12:21 pm ] |
| Post subject: | g13a wont idle after head gasket change. |
Hey guys ,just finished a head gasket change on my zook. It started fine and ran and idled nicely, then after a run down the freeway it cuts out at 1500 rpm and just wont idle. Runs smooth above that rpm . I changed the inlet and ex manifold gaskets, rocker cover gasket and timing belt. |
|
| Author: | BrumbyBoy [ Sun Mar 11, 2012 1:15 pm ] |
| Post subject: | Re: g13a wont idle after head gasket change. |
Sounds like a vacuum leak to me, id be checking all your vacuum hoses are connected and then ensure the intake manifold is sealed properly. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|