auszookers.com
http://auszookers.com/forum/

Calmini Transfer Case Cradle
http://auszookers.com/forum/viewtopic.php?f=5&t=31250		 Page 1 of 1
Author:  XLZook [ Sun Mar 18, 2012 3:31 pm ]
Post subject:  Calmini Transfer Case Cradle
Hi there Guys,

I seem to have run into a little problem with my new Calmini Transfer Case Cradle :( When I try to put the cradle onto the transfer case ( I have it upside down on the bench so that i can put the cradle onto the case rather than the other way around) the mounting points are too close together and wont allow the cradle to fit on to the case.

Would it be ok to mill down that part of the casting or should i look at sending it back to get another one?

Any help that anyone can give me will be greatly appreciated!

Thanks Heaps!
Author:  abclarke [ Sun Mar 18, 2012 3:43 pm ]
Post subject:  Re: Calmini Transfer Case Cradle
Personally, id send it back. Why pay for something that isnt right?
Author:  stockman [ Sun Mar 18, 2012 4:29 pm ]
Post subject:  Re: Calmini Transfer Case Cradle
I had to jiggle mine on.
Author:  XLZook [ Sun Mar 18, 2012 7:19 pm ]
Post subject:  Re: Calmini Transfer Case Cradle
Cool I think Ill hit up the guys I bought it from and see if they can get me a new one, the size difference is 30mm and unless i mill down the casting its not going on :/
hopefuly they can give me one that fits! :P
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/