| auszookers.com http://auszookers.com/forum/ |
|
| Transfer question http://auszookers.com/forum/viewtopic.php?f=5&t=3144 |
Page 1 of 1 |
| Author: | Mike [ Sun Oct 12, 2008 11:34 pm ] |
| Post subject: | Transfer question |
apart from having different output flanges are there any other differences between a nt and wt transfer case? Cheers |
|
| Author: | lump_a_charcoal [ Sun Oct 12, 2008 11:54 pm ] |
| Post subject: | Re: Transfer question |
Pretty much no I believe. I just bought one of each, and they are just the same. |
|
| Author: | Mike [ Sun Oct 12, 2008 11:57 pm ] |
| Post subject: | Re: Transfer question |
does the wt case have the holes to mount at handbrake on it? |
|
| Author: | lump_a_charcoal [ Sun Oct 12, 2008 11:59 pm ] |
| Post subject: | Re: Transfer question |
Can't say - never seen a handbrake drum there. |
|
| Author: | joeblow [ Mon Oct 13, 2008 1:44 am ] |
| Post subject: | Re: Transfer question |
yes it does. |
|
| Author: | Mike [ Mon Oct 13, 2008 1:47 am ] |
| Post subject: | Re: Transfer question |
so the wt case will bolt straight into a nt with the hand brake on the case? |
|
| Author: | joeblow [ Mon Oct 13, 2008 2:04 am ] |
| Post subject: | Re: Transfer question |
if using the right flange patterns yes. |
|
| Author: | Mike [ Mon Oct 13, 2008 2:09 am ] |
| Post subject: | Re: Transfer question |
thats exactly what i wanted to hear thanks Joe |
|
| Author: | just_cruizin [ Mon Oct 13, 2008 2:17 am ] |
| Post subject: | Re: Transfer question |
The NT uni flanges have a smaller od on the spigot then the WT so you can redrill WT flanges to accept the NT uni flanges but not the other way around. The casings are the same in every way. |
|
| Author: | Mike [ Mon Oct 13, 2008 2:19 am ] |
| Post subject: | Re: Transfer question |
thats alright i was just planning on swapping the flanges off one to the other |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|