| auszookers.com http://auszookers.com/forum/ |
|
| Sill pinch join thingy... http://auszookers.com/forum/viewtopic.php?f=5&t=3163 |
Page 1 of 1 |
| Author: | lump_a_charcoal [ Wed Oct 15, 2008 6:08 am ] |
| Post subject: | Sill pinch join thingy... |
G'day - Would there be any problem with hammering the pinch under the sill flat, so I can fit some angle under there, or is cutting it off ok? I want to make some sliders similar to the shrockworks ones.. |
|
| Author: | twitchy [ Wed Oct 15, 2008 10:13 am ] |
| Post subject: | Re: Sill pinch join thingy... |
Possibly be a good rust collector if you hammer them flat, don't think you will cut them off unless you can seal them again. |
|
| Author: | steve [ Wed Oct 15, 2008 10:19 am ] |
| Post subject: | Re: Sill pinch join thingy... |
They do have drain gaps in the seams too so carefull not to block them. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|