regular thread. i used a 3/4in rattle gun to get mine out. Tough bastard, try heating if you can but impact is your best bet
good luck mate.
| auszookers.com http://auszookers.com/forum/ |
|
| G16b undoing crankshaft gear bolt http://auszookers.com/forum/viewtopic.php?f=5&t=31667 |
Page 1 of 1 |
| Author: | burls [ Thu Apr 05, 2012 9:37 am ] |
| Post subject: | G16b undoing crankshaft gear bolt |
Im having trouble getting the bolt undone. is it left hand or right hand thread? |
|
| Author: | Llewellyn92 [ Thu Apr 05, 2012 11:42 am ] |
| Post subject: | Re: 16b crankshaft gear |
regular thread. i used a 3/4in rattle gun to get mine out. Tough bastard, try heating if you can but impact is your best bet good luck mate.
|
|
| Author: | burls [ Thu Apr 05, 2012 12:11 pm ] |
| Post subject: | Re: 16b crankshaft gear |
thanks I thought it was. Boy is it tight |
|
| Author: | tsock0 [ Wed May 02, 2012 6:32 pm ] |
| Post subject: | Re: 16b crankshaft gear |
Best way is to get 17 mm socket on a breaker bar and lock it into place and give your key a quick turn, works every time |
|
| Author: | Fatzook [ Wed May 02, 2012 6:54 pm ] |
| Post subject: | Re: 16b crankshaft gear |
tsock0 wrote: Best way is to get 17 mm socket on a breaker bar and lock it into place and give your key a quick turn, works every time WITH THE IGNITION LEAD DISCONNECTED!!!!! |
|
| Author: | burls [ Wed May 02, 2012 7:47 pm ] |
| Post subject: | Re: 16b crankshaft gear |
Yeah got it. Hardest bit was holding the engine still (wasnt in a car) I used two 4m bars to get it undone. Anyway the block and crank I scored are in good nick |
|
| Author: | tsock0 [ Thu May 03, 2012 10:49 am ] |
| Post subject: | Re: 16b crankshaft gear |
What happens I'd u don't disconnect ignition lead I dont |
|
| Author: | Jester [ Fri May 04, 2012 9:04 pm ] |
| Post subject: | Re: 16b crankshaft gear |
tsock0 wrote: What happens I'd u don't disconnect ignition lead I dont engine runs, so you screw everything up |
|
| Author: | Fatzook [ Fri May 04, 2012 9:08 pm ] |
| Post subject: | Re: 16b crankshaft gear |
Jester wrote: tsock0 wrote: What happens I'd u don't disconnect ignition lead I dont engine runs, so you screw everything up Further to this.... The engine starts, and runs. What happens next can range from nothing at all, to someone or something getting nailed by a rapidly moving breaker bar and 17mm socket. You don't need ignition, you just need the motor to crank over on the starter a few turns. 
|
|
| Author: | tsock0 [ Sat May 05, 2012 10:08 am ] |
| Post subject: | Re: 16b crankshaft gear |
thats what i mean u just tick the key so it cracks the bolt pretty simple |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|