| auszookers.com http://auszookers.com/forum/ |
|
| Non switched 1l case disassembly. http://auszookers.com/forum/viewtopic.php?f=5&t=32264 |
Page 1 of 1 |
| Author: | sideways [ Tue May 01, 2012 9:35 pm ] |
| Post subject: | Non switched 1l case disassembly. |
So the charming thing is jammed in neutral and the stick will not come out. Can I remove the front part of the case (the part that holds the FWD output and the stick) whilst it's in the car? My main concern is bits falling out, I have a dirt floor shed you see. I'm also not sure if I'l be able to slide off the front part without removing the stick. Are there any crush sleeves ect I'l have to replace? Anyone got a diagram from the parts manual? Thanks Hayden |
|
| Author: | scorpydude [ Wed May 02, 2012 9:52 am ] |
| Post subject: | Re: Non switched 1l case disassembly. |
this might help... http://www.trail-gear.com/tech/zuk65gears/index.html http://bbs.zuwharrie.com/content?topic=61607.0 http://www.4x4.in.th/manual_sj413/index.html or specifically - http://www.4x4.in.th/manual_sj413/chapter14.pdf |
|
| Author: | 303zuke [ Wed May 02, 2012 11:36 am ] |
| Post subject: | Re: Non switched 1l case disassembly. |
sideways wrote: So the charming thing is jammed in neutral and the stick will not come out. Can I remove the front part of the case whilst it's in the car? I'm also not sure if I'll be able to slide off the front part without removing the stick. Anyone got a diagram from the parts manual? Thanks Hayden No, you won't get the front case half off because the stick will be engaged in the 4H-N-4L shaft and it won't slide off. The non-switched case is different in many details to the switched case, but close enough that the links to the switched case technical stuff that Scorpy gave will help. Here's a breakdown of the non-switched case. I'd remove the bolts marked in red to assist in removing the lever. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|