You been watchin to many kids shows......... If they have B1 & B2 in them they are Bananas!!!!!!!!
| auszookers.com http://auszookers.com/forum/ |
|
| Standard Piston Size? http://auszookers.com/forum/viewtopic.php?f=5&t=32430 |
Page 1 of 1 |
| Author: | tonyevans [ Tue May 08, 2012 12:32 pm ] |
| Post subject: | Standard Piston Size? |
1992 G16B EFI Motor If the pistons only have an arrow and B1 or B2 on the top are they standard size? IE The engine has NOT been re-bored at all? Tony |
|
| Author: | want33s [ Tue May 08, 2012 12:39 pm ] |
| Post subject: | Re: Standard Piston Size? |
Oversize pistons nearly always have .030 or similar stamped into the crown. G16A & B Standard bore is 75.0mm |
|
| Author: | tonyevans [ Wed May 09, 2012 3:22 pm ] |
| Post subject: | Re: Standard Piston Size? |
Thanks Wants - that is how I have always seen it but with Suzuki might have been different - What made me ask is the motor or should I say car has 235,000 k's on it and there is no sigh of a ridge at the top of the bores at all. I can not even feel a thing when I run my nail up it. Just thought it must have been re-bored but is the pistons are standard it must have had a very soft life. |
|
| Author: | twitchy [ Thu May 10, 2012 5:00 am ] |
| Post subject: | Re: Standard Piston Size? |
You been watchin to many kids shows......... If they have B1 & B2 in them they are Bananas!!!!!!!!
|
|
| Author: | tonyevans [ Thu May 10, 2012 7:39 am ] |
| Post subject: | Re: Standard Piston Size? |
That would explain no wear on the bores |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|