| auszookers.com http://auszookers.com/forum/ |
|
| Transfer Noise ? http://auszookers.com/forum/viewtopic.php?f=5&t=32540 |
Page 1 of 1 |
| Author: | xedent [ Sat May 12, 2012 10:17 am ] |
| Post subject: | Transfer Noise ? |
I just installed 4.9's and all new bearings into a tcase i bought. Don't know what i did wrong but its making a 'tick, tick, tick' noise? It does have oil lol The noise only happens on acceleration, just coasting / going down gears no noise. Sounds like its coming from the front of the car, if i put tcase into Neutral and 5th gear and accelerate no noise. Here is a movie of it. 
|
|
| Author: | Teracis [ Sat May 12, 2012 11:06 am ] |
| Post subject: | Re: Transfer Noise ? |
It sounds like the jackshaft or a tailshaft is rubbing on something or vice versa. It's only doing it under acceleration because of the load twisting the transfer mounts e.t.c. just enough to make it touch. Does it do it on overrun or just acceleration, it doesn't sound like a gears problem otherwise it would be there the whole time. Check for loose wires and cable ties and spots that may be rubbed e.t.c. I know the way mine is setup (transfer boot flipped) I had to pull the boot up high out of the way of the shaft, horrible horrible noise that made! |
|
| Author: | xedent [ Sat May 12, 2012 11:30 am ] |
| Post subject: | Re: Transfer Noise ? |
Thanks for that, I just pulled case back out, do you think it might be the input flang as its got a mark where it's been touching ? |
|
| Author: | SierraDan [ Sat May 12, 2012 11:39 am ] |
| Post subject: | Re: Transfer Noise ? |
Got an Smartarse mates that tied a cable tie around a shaft? Haha |
|
| Author: | xedent [ Sat May 12, 2012 11:44 am ] |
| Post subject: | Re: Transfer Noise ? |
SierraDan wrote: Got an Smartarse mates that tied a cable tie around a shaft? Haha Hahaha that's a good idea for someone! |
|
| Author: | xedent [ Sat May 12, 2012 1:34 pm ] |
| Post subject: | Re: Transfer Noise ? |
yeah it was just the seal guard on the flange, had me worried ! I actually have low range now !! |
|
| Author: | stockman [ Sat May 12, 2012 3:06 pm ] |
| Post subject: | Re: Transfer Noise ? |
Did you end up using the chipped gear? |
|
| Author: | xedent [ Sat May 12, 2012 3:09 pm ] |
| Post subject: | Re: Transfer Noise ? |
Yeah i did, i asked a few diff places and they said if the chip is smaller then a match head it will be fine so ill see how it goes. |
|
| Author: | Teracis [ Sat May 12, 2012 11:24 pm ] |
| Post subject: | Re: Transfer Noise ? |
Hah, good to see I was on the money for once! You can just tap the dust covers back onto the flange with a hammer, take it easy though. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|