I changed mine from the top as well wasnt that hard just tricking getting the bolts to take
| auszookers.com http://auszookers.com/forum/ |
|
| gearbox removal http://auszookers.com/forum/viewtopic.php?f=5&t=34116 |
Page 1 of 1 |
| Author: | Shift [ Thu Jul 12, 2012 9:19 pm ] |
| Post subject: | gearbox removal |
Hey guys, tried removing the gearbox this arvo to replace the clutch on my sierra...thought it would be an easier job than my old 4runner. How do you guys go about removing the start motor? Any other tips for removing the gearbox appreciated! |
|
| Author: | shep [ Thu Jul 12, 2012 9:22 pm ] |
| Post subject: | Re: gearbox removal |
Starter is best removed from underneath the car and ya need to remove the shifter and jack shaft. Also rotate the box as it comes out. |
|
| Author: | want33s [ Fri Jul 13, 2012 6:35 am ] |
| Post subject: | Re: gearbox removal |
I'm near on 6'5" tall and my hands arn't exactly small but I've always removed and refitted starters from the top. If it is a 1.3 cut 7-8mm off the front edge of the gearbox mount on th chassis. Gives enough room to drop bellhousing past pressure plate. I did this just yesterday (in the rain) on a NT tintop. |
|
| Author: | shiv [ Fri Jul 13, 2012 10:32 am ] |
| Post subject: | Re: gearbox removal |
I changed mine from the top as well wasnt that hard just tricking getting the bolts to take
|
|
| Author: | BlueSuzy [ Fri Jul 13, 2012 11:13 am ] |
| Post subject: | Re: gearbox removal |
Gearbox in/out is a 1 man job with no assistance Unlike 4runner |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|