Why don't you buy a D44 front and D60 rear from an F150? Cheaper than custom, and off the shelf parts are at your fingertips. Also, you're keeping it in the Spicer family
| auszookers.com http://auszookers.com/forum/ |
|
| Axle / Diff strength http://auszookers.com/forum/viewtopic.php?f=5&t=34225 |
Page 1 of 1 |
| Author: | mrwilley [ Mon Jul 16, 2012 4:58 pm ] |
| Post subject: | Axle / Diff strength |
Out of the solid axle Suzuki's which one would you say have the strongest Axle / Diffs.? And what would be the max tyre diameter could you run with them? Would an old V8 rip them apart? The reason I am asking is I am after a set of diffs to replace a Dana 25 in a Willeys jeep project I have going and wondering if a set of Sierra diffs could work. It has a V8 in it, and the front diff just isn't strong enough the rear is a dana 44. I have been looking at going with Hilux diffs but the width is too wide for my liking and would like to avoid cutting the rear gaurds. My other option would be a custom set of diffs. |
|
| Author: | got_bar_work [ Mon Jul 16, 2012 5:23 pm ] |
| Post subject: | Re: Axle / Diff strength |
What size tire u want to run A sierra diff with cromo might run a 31 with cromo if u r nice on the juice but if u r heavy on the right foot the v8 would rip it apart |
|
| Author: | rustyzook [ Mon Jul 16, 2012 5:34 pm ] |
| Post subject: | Re: Axle / Diff strength |
not sure about rocky diffs? may work, but prob not. custom lux diffs cut down to size? |
|
| Author: | 2stroker [ Mon Jul 16, 2012 6:03 pm ] |
| Post subject: | Re: Axle / Diff strength |
Hilux |
|
| Author: | rpmwrx [ Mon Jul 16, 2012 6:39 pm ] |
| Post subject: | Re: Axle / Diff strength |
A front sierra diff running chromo axles and cv's is good for anything upto a 35 inch tyre. |
|
| Author: | rustyzook [ Mon Jul 16, 2012 6:53 pm ] |
| Post subject: | Re: Axle / Diff strength |
but with a v8 pushing it? what engine is it? whats the killowasps? |
|
| Author: | 2stroker [ Mon Jul 16, 2012 6:54 pm ] |
| Post subject: | Re: Axle / Diff strength |
Seriously I would not even consider a Sierra diff, chromos or not, if you are running a V8 you will break it. Now lots of people will say even Hilux is not strong enough but don't forget he has a little Willeys ( I mean his Jeep, sorry mrwilley) so Patrol or cruiser diffs are just too big heavy and bulky. You can buy so much aftermarket stuff for hilux diffs and you have the option of running shortened hilux drive shafts and even hilux gearbox and transfer if you wanted to. |
|
| Author: | 2stroker [ Mon Jul 16, 2012 6:58 pm ] |
| Post subject: | Re: Axle / Diff strength |
In the olden days I had a 40 series landcruiser with a 308 holden V8 and 32" tyres, I broke 2 rear diffs and a few axles as well that was an old dunger V8 not a good one |
|
| Author: | twitchy [ Mon Jul 16, 2012 7:23 pm ] |
| Post subject: | Re: Axle / Diff strength |
The mad bugger who used to have the suzuki dealership at Little Hartley ( near Lithgow for the others) put a rover V8 & auto into a sierra & it was quite drivable. |
|
| Author: | KEENSY85 [ Mon Jul 16, 2012 9:02 pm ] |
| Post subject: | Re: Axle / Diff strength |
2stroker wrote: Seriously I would not even consider a Sierra diff, chromos or not, if you are running a V8 you will break it. Now lots of people will say even Hilux is not strong enough but don't forget he has a little Willeys ( I mean his Jeep, sorry mrwilley) so Patrol or cruiser diffs are just too big heavy and bulky. You can buy so much aftermarket stuff for hilux diffs and you have the option of running shortened hilux drive shafts and even hilux gearbox and transfer if you wanted to. even hilux would be a stretch shurly a v8 is not neccacary |
|
| Author: | Fatzook [ Mon Jul 16, 2012 10:02 pm ] |
| Post subject: | Re: Axle / Diff strength |
KEENSY85 wrote: even hilux would be a stretch shurly a v8 is not neccacary No. Hilux is fine with a V8. |
|
| Author: | oozuk [ Mon Jul 16, 2012 10:24 pm ] |
| Post subject: | Re: Axle / Diff strength |
Fatzook wrote: KEENSY85 wrote: even hilux would be a stretch shurly a v8 is not neccacary No. Hilux is fine with a V8. X2 forget anything suzuki altogether for what you want and look toyota |
|
| Author: | want33s [ Mon Jul 16, 2012 10:30 pm ] |
| Post subject: | Re: Axle / Diff strength |
What about Jeep diffs EG TJ Wrangler? Made to handle a torquey 4.0litre 6 cylinder. Easily upgraded with aftermarket bits if need be. |
|
| Author: | Fatzook [ Mon Jul 16, 2012 10:32 pm ] |
| Post subject: | Re: Axle / Diff strength |
Why don't you buy a D44 front and D60 rear from an F150? Cheaper than custom, and off the shelf parts are at your fingertips. Also, you're keeping it in the Spicer family
|
|
| Author: | BlueSuzy [ Mon Jul 16, 2012 11:26 pm ] |
| Post subject: | Re: Axle / Diff strength |
Rocky diffs are good for the bin imo. |
|
| Author: | Fatzook [ Mon Jul 16, 2012 11:28 pm ] |
| Post subject: | Re: Axle / Diff strength |
want33s wrote: What about Jeep diffs EG TJ Wrangler? Made to handle a torquey 4.0litre 6 cylinder. Easily upgraded with aftermarket bits if need be. Front is D30. They are the first thing to go in the bin once a v8 is fitted. |
|
| Author: | mrwilley [ Tue Jul 17, 2012 8:27 am ] |
| Post subject: | Re: Axle / Diff strength |
Fatzook wrote: want33s wrote: What about Jeep diffs EG TJ Wrangler? Made to handle a torquey 4.0litre 6 cylinder. Easily upgraded with aftermarket bits if need be. Front is D30. They are the first thing to go in the bin once a v8 is fitted. The pumpkin is on the wrong side aswell. Early D30 from jeep up to the early 60's would bolt straight in, but they are no where to be found in Australia. The D30 can be built up fairly easily, and would handle the V8 (aprox 190hp). The other issue that most people forget about when doing engine transfers and particulary in my case is the extra weight that is put onto the axle housing. A sierra diff would have to be trussed as well not a big issue. I have thought about F150 Diffs but again it is the extra width that I do not like. When the Hilux diffs are put into the Suzuki's are they shortened or do most people keep the Hilux width? Anybody know of any one that does custom diffs for 4wd's around the Melbourne area? |
|
| Author: | sideways [ Tue Jul 17, 2012 9:11 am ] |
| Post subject: | Re: Axle / Diff strength |
mrwilley wrote: Fatzook wrote: want33s wrote: What about Jeep diffs EG TJ Wrangler? Made to handle a torquey 4.0litre 6 cylinder. Easily upgraded with aftermarket bits if need be. Front is D30. They are the first thing to go in the bin once a v8 is fitted. The pumpkin is on the wrong side aswell. Early D30 from jeep up to the early 60's would bolt straight in, but they are no where to be found in Australia. The D30 can be built up fairly easily, and would handle the V8 (aprox 190hp). The other issue that most people forget about when doing engine transfers and particulary in my case is the extra weight that is put onto the axle housing. A sierra diff would have to be trussed as well not a big issue. I have thought about F150 Diffs but again it is the extra width that I do not like. When the Hilux diffs are put into the Suzuki's are they shortened or do most people keep the Hilux width? Anybody know of any one that does custom diffs for 4wd's around the Melbourne area? HiLux front diffs are only 57mm wider than a WT Sierra front diff so there's really no point in going to all the effort of narrowing it. 
|
|
| Author: | KEENSY85 [ Tue Jul 17, 2012 1:38 pm ] |
| Post subject: | Re: Axle / Diff strength |
why not just buy a lux and atach a sierra cab |
|
| Author: | Zook_Fan [ Tue Jul 17, 2012 1:41 pm ] |
| Post subject: | Re: Axle / Diff strength |
KEENSY85 wrote: why not just buy a lux and atach a sierra cab Did you even read the post? He is looking to see whether it is a good idea to use sierra diffs under a willeys jeep 
|
|
| Author: | 303zuke [ Wed Jul 18, 2012 1:15 am ] |
| Post subject: | Re: Axle / Diff strength |
twitchy wrote: The mad bugger who used to have the suzuki dealership at Little Hartley ( near Lithgow for the others) put a rover V8 & auto into a sierra & it was quite drivable. I wouldn't call him a Mad Bugger, but the Daltek is still driving around today. |
|
| Author: | KEENSY85 [ Wed Jul 18, 2012 6:22 am ] |
| Post subject: | Re: Axle / Diff strength |
Zook_Fan wrote: KEENSY85 wrote: why not just buy a lux and atach a sierra cab   Did you even read the post? He is looking to see whether it is a good idea to use sierra diffs under a willeys jeep No I didn't L OL not pro :r  ambo: perly I had a few to many bears Rolf , my bad ( if u drink the auszook ur bloody idiot. LOl sor guys :b
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|