auszookers.com
http://auszookers.com/forum/

King pin bearings.
http://auszookers.com/forum/viewtopic.php?f=5&t=34697		 Page 1 of 1
Author:  jmd-247 [ Fri Aug 03, 2012 3:51 pm ]
Post subject:  King pin bearings.
I have now stripped a front diff/axle housing to nothing.
Just looking at king pin bearings.
I was expecting ( never done king pin bearings before!) to be able to remove the outer race to the bearing.
They are wide track Diffs, the issue is the race, or lack of it. The bearing just sits in the taper?
Obviously which must get machined if damaged?
If there is a race there I'm blind!!
Is this right?
Thanks josh.

BTW. I did search and don't find anything specific. :oops:
Author:  SierraDan [ Fri Aug 03, 2012 4:37 pm ]
Post subject:  Re: King pin bearings.
When you buy new bearings you get we races which tap in/out of the knuckle.
Author:  jmd-247 [ Fri Aug 03, 2012 4:50 pm ]
Post subject:  Re: King pin bearings.
Yeah I got the races with the bearings. But I couldn't see if there were a race in the housing. Quite rusty.
I'll give it a go tomorrow.
Thanks Dan.
Author:  Jazzor [ Fri Aug 03, 2012 5:05 pm ]
Post subject:  Re: King pin bearings.
The race edges stick out of the housing, and are a different color metal. So they should be hard to miss if you give everything a good clean!

Got a pic of it now?, I'd be interested to see whats rusty.
Author:  SierraDan [ Fri Aug 03, 2012 5:21 pm ]
Post subject:  Re: King pin bearings.
In the bare knuckle balls there will be a seat for it to sit in top and bottom
Author:  jmd-247 [ Fri Aug 03, 2012 5:33 pm ]
Post subject:  Re: King pin bearings.
Yeah its all rusty!! Haha
Got it but. All good.
They were out in the weather for years with not much oil/Grease in them.
They were cheap. Real cheap. Other than this they look good. :)
Thanks fellas.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/