| auszookers.com http://auszookers.com/forum/ |
|
| putting in vitara SWB lift need help http://auszookers.com/forum/viewtopic.php?f=5&t=35041 |
Page 1 of 1 |
| Author: | 1oftheboys [ Fri Aug 17, 2012 10:13 pm ] |
| Post subject: | putting in vitara SWB lift need help |
Putting in a 2inch lift in an 89 vitara and a bit stuck. Where do the 2 smaller blocks in the BYE lift go? Sure its obvious but just can't work out where! |
|
| Author: | atari4x4 [ Fri Aug 17, 2012 10:55 pm ] |
| Post subject: | Re: putting in vitara SWB lift need help |
the 2 non fixed blocks on a swb vit go on the chassis rails near the mount for the rear springs. there should be a rubber pad there, this is a support for the load area. some sikaflex or any sort of adhesive will be enough to hold them in place. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|