just_cruizin wrote:
cold chisel
just play khe sahn really loud and the doors will fall off
| auszookers.com http://auszookers.com/forum/ |
|
| getting dorrs off http://auszookers.com/forum/viewtopic.php?f=5&t=3515 |
Page 1 of 1 |
| Author: | _noddy [ Tue Dec 09, 2008 3:23 am ] |
| Post subject: | getting dorrs off |
Im trying to get my doors off but the bolts are shit i have tryed one of theos bashey things wat eles can i try. |
|
| Author: | Mike [ Tue Dec 09, 2008 3:28 am ] |
| Post subject: | Re: getting dorrs off |
weld a nut onto the screw and use a ratchet/breaker bar |
|
| Author: | just_cruizin [ Tue Dec 09, 2008 4:07 am ] |
| Post subject: | Re: getting dorrs off |
cold chisel |
|
| Author: | Mike [ Tue Dec 09, 2008 4:25 am ] |
| Post subject: | Re: getting dorrs off |
just_cruizin wrote: cold chisel
just play khe sahn really loud and the doors will fall off
|
|
| Author: | BlueSuzy [ Tue Dec 09, 2008 4:28 am ] |
| Post subject: | Re: getting dorrs off |
 Now what the?
|
|
| Author: | hooki [ Tue Dec 09, 2008 8:25 am ] |
| Post subject: | Re: getting dorrs off |
haha jimmy barnes |
|
| Author: | royce [ Tue Dec 09, 2008 11:52 am ] |
| Post subject: | Re: getting dorrs off |
Blow torch |
|
| Author: | Damo [ Tue Dec 09, 2008 1:53 pm ] |
| Post subject: | Re: getting dorrs off |
You can try mechanical methods like the impact driver or a cold chisel. I have used the big screwdriver bit from the impact driver and put it onto my rattle gun  which worked a few times but after a while it just shatters the bit like glass!!
If none of that works you need to introduce some heat. Like Royce mentioned a blow torch should do it. An oxy will work too. If you weld a nut onto the head of the bolt the heat from the weld will make it easy to undo, and as a bonus you willnow have a nut to put a spanner on too. |
|
| Author: | just_cruizin [ Wed Dec 10, 2008 6:14 am ] |
| Post subject: | Re: getting dorrs off |
park on a main street and throw the door open when a taxi goes past. |
|
| Author: | appsie [ Thu Dec 11, 2008 2:26 am ] |
| Post subject: | Re: getting dorrs off |
i like some of these methods fellas.I have always done mine with a cold chisel and tapped it loose tho.can be a pain at times but once your running bolts instead of those ridiculous screws its great |
|
| Author: | Hybrid [ Thu Dec 11, 2008 6:19 pm ] |
| Post subject: | Re: getting dorrs off |
You could cut the top tube of your hinge off and make the doors removable. Thats what I did so I could swap between full doors and half doors (yet to be cut down). You just open the doors and lift them off. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|