| auszookers.com http://auszookers.com/forum/ |
|
| Arb Part numbers, Any real relevance to real world specs http://auszookers.com/forum/viewtopic.php?f=5&t=36111 |
Page 1 of 1 |
| Author: | tanshi [ Wed Oct 03, 2012 3:56 pm ] |
| Post subject: | Arb Part numbers, Any real relevance to real world specs |
So ive been doing some searching around. Some part numbers i have found for ARB side gear sets for various diffs are 728H081 728J081 Im hoping some one in the know, i.e Jowblow or some one else who has real world info can tell me if the H / J etc has any real world relevance to axle shaft sizes or spline counts etc. |
|
| Author: | Fatzook [ Wed Oct 03, 2012 6:14 pm ] |
| Post subject: | Re: Arb Part numbers, Any real relevance to real world specs |
tanshi wrote: So ive been doing some searching around. Some part numbers i have found for ARB side gear sets for various diffs are 728H081 728J081 Im hoping some one in the know, i.e Jowblow or some one else who has real world info can tell me if the H / J etc has any real world relevance to axle shaft sizes or spline counts etc. Plastic or steel pistons? |
|
| Author: | joeblow [ Wed Oct 03, 2012 7:21 pm ] |
| Post subject: | Re: Arb Part numbers, Any real relevance to real world specs |
As far as I know the 'J' and 'H' designation is for size of the gear not including the spline. For example there may 10 versions of a 'J' sidegear with different splines. Your best bet is to tell me what spline count you are after including from what make and I will see if I can match something up for you. |
|
| Author: | tanshi [ Thu Oct 04, 2012 8:30 am ] |
| Post subject: | Re: Arb Part numbers, Any real relevance to real world specs |
So the J gear is the same size and shape in all the lockers its used in, but has a different size spline through the middle? IM looking at the possibilities of upsizing the spline and size of rear axles in a vit centre. running full floats with bigger outers aswell |
|
| Author: | tanshi [ Thu Oct 04, 2012 8:31 am ] |
| Post subject: | Re: Arb Part numbers, Any real relevance to real world specs |
Fatzook wrote: tanshi wrote: So ive been doing some searching around. Some part numbers i have found for ARB side gear sets for various diffs are 728H081 728J081 Im hoping some one in the know, i.e Jowblow or some one else who has real world info can tell me if the H / J etc has any real world relevance to axle shaft sizes or spline counts etc. Plastic or steel pistons? these are later model lockers so not plastic i think |
|
| Author: | tanshi [ Thu Oct 04, 2012 9:06 am ] |
| Post subject: | Re: Arb Part numbers, Any real relevance to real world specs |
from what i can find. 28.8mm or 30.8 shaft diameters. any one got a vitara rear airlocker thay can measure the snouts of to see if either of those sizes will fit? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|