| auszookers.com http://auszookers.com/forum/ |
|
| Wheel Aligment adds extra height? http://auszookers.com/forum/viewtopic.php?f=5&t=36124 |
Page 1 of 1 |
| Author: | suzukiboy [ Wed Oct 03, 2012 8:10 pm ] |
| Post subject: | Wheel Aligment adds extra height? |
I get wheel alignments regularly on my Vitara and after the last one a couple of weeks ago the front end is now a lot higher. I have the Calmini lift with arb bullbar and the front has dropped since it was installed. After every wheel alignment you could see the front was lower then the back. But now I think I have gained a inch or two. Not sure what is going on there. Maybe they left the wheel alignment machine under the car. |
|
| Author: | Fatzook [ Wed Oct 03, 2012 8:13 pm ] |
| Post subject: | Re: Wheel Aligment adds extra height? |
Did you think to ask what they have done differently? |
|
| Author: | suzukiboy [ Wed Oct 03, 2012 8:21 pm ] |
| Post subject: | Re: Wheel Aligment adds extra height? |
Fatzook wrote: Did you think to ask what they have done differently? No I haven't been back, I thought of going back but they might think I am some sort of nut and bust out laughing. I am going to replace the Heim Joint, and get a mechanic mate to do it will get him look over it. |
|
| Author: | royce [ Wed Oct 03, 2012 8:42 pm ] |
| Post subject: | Re: Wheel Aligment adds extra height? |
too much toe in makes the front lift and the tyres try ad drive under the car and it pulls the arms up |
|
| Author: | suzukiboy [ Wed Oct 03, 2012 8:45 pm ] |
| Post subject: | Re: Wheel Aligment adds extra height? |
It did have a bit of tow out on one wheel, but looks fine as it sits now, might have to get the tape measure out and check. |
|
| Author: | HellonWheels [ Wed Oct 03, 2012 8:45 pm ] |
| Post subject: | Re: Wheel Aligment adds extra height? |
You should get a print-out of before and after measurements from where you get it alligned. |
|
| Author: | suzukiboy [ Wed Oct 03, 2012 8:54 pm ] |
| Post subject: | Re: Wheel Aligment adds extra height? |
HellonWheels wrote: You should get a print-out of before and after measurements from where you get it alligned. Yes I did, was ok after alignment. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|