| auszookers.com http://auszookers.com/forum/ |
|
| Transfer case rear output seal - what size is the nut? http://auszookers.com/forum/viewtopic.php?f=5&t=37220 |
Page 1 of 1 |
| Author: | kd883 [ Mon Nov 19, 2012 8:36 am ] |
| Post subject: | Transfer case rear output seal - what size is the nut? |
Hi guys, I noticed this morning that my transfer case is leaking. Looks like the rear output seal has gone. Does anyone know what size the nut is in front of the seal? I tried to do the diff pinion seal a while ago but my sockets weren't big enough. I have a feeling I will have the same problem with this one, so I'd like to buy the correct socket before I start job this arvo. Cheers, KD. |
|
| Author: | mrw82 [ Mon Nov 19, 2012 9:31 am ] |
| Post subject: | Re: Transfer case rear output seal - what size is the nut? |
27mm socket. And you will need a GOOD STRONG. Rattle gun. |
|
| Author: | Fatzook [ Mon Nov 19, 2012 9:40 am ] |
| Post subject: | Re: Transfer case rear output seal - what size is the nut? |
mrw82 wrote: 27mm socket. And you will need a GOOD STRONG. Rattle gun. And a good strong socket! Impact socket preferably. I had a 1/2" drive 27 open up on me last year. Lucky I was wearing safety glasses! If you absolutely have to use a normal one, wrap it with some fibreglass reinforced tape first. 
|
|
| Author: | Jackson [ Mon Nov 19, 2012 9:42 am ] |
| Post subject: | Re: Transfer case rear output seal - what size is the nut? |
Yeah it is tight as. Easier just to go to a tyre shop. The fella was even nice enough to do it for free. |
|
| Author: | kd883 [ Mon Nov 19, 2012 1:45 pm ] |
| Post subject: | Re: Transfer case rear output seal - what size is the nut? |
Thank you very much gentlemen. KD. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|