Ok I am selling my Sierra which had a 1600 fitted, I sold that and put a standard 1328CC G13A back in it. When I first put the motor in it would start after cranking for 10-15 seconds, if I turned it off and restarted it immediately it would start with no delay. It was left sitting for about a month and when I came back it would not start. I managed to work out there was no fuel getting to the carby by pouring petrol in the crby, it ran when I did that. So I disconnected the inlet hose on the fuel pump and placed in in a tin of petrol, still no joy. I assumed the pump was buggered, so I bought a new one, looks exactly the same. Fitted that and still nothing, tried the tin trick again, no difference. So I removed the pump and checked out the rod and it was a bit stuck, so I cleaned it and greased it so it moved easily, put it all back together and the POS still won't go, anybody got any suggestions please?
Stupid spring clamp on the supply line wasn't doing its job, replaced with a proper hose clamp and she's away! 