auszookers.com
http://auszookers.com/forum/

NT Diff ratio 1L Transfer ratio
http://auszookers.com/forum/viewtopic.php?f=5&t=39118		 Page 1 of 1
Author:  barlow [ Wed Feb 20, 2013 5:09 pm ]
Post subject:  NT Diff ratio 1L Transfer ratio
Hey probably be covered a million times but can someone tell me what the NT diff ratios are compared to the WT. Also what the 1L transfer case ratio to the 1.3L.
Author:  Gwagensteve [ Wed Feb 20, 2013 5:33 pm ]
Post subject:  Re: NT Diff ratio 1L Transfer ratio
1.3: high 1.409, low 2.21, diff 3.9 (nt) 3.7 (wt)
1.0: high 1.59, low 2.55, diff 4.1

Also consider first gear for a 1.0 is about 3:1, for a 1.3 it's 3.65:1

Some of these numbers might be a bit loose, they're from memory.

Steve.
Author:  barlow [ Wed Feb 20, 2013 6:54 pm ]
Post subject:  Re: NT Diff ratio 1L Transfer ratio
Thanks. Also The wt and nt axle splines are they the same? So I can use a nt diff center in a wt diff housing with the wt axles?
Author:  Gwagensteve [ Wed Feb 20, 2013 7:07 pm ]
Post subject:  Re: NT Diff ratio 1L Transfer ratio
Yes..
Author:  barlow [ Wed Feb 20, 2013 7:11 pm ]
Post subject:  Re: NT Diff ratio 1L Transfer ratio
okay awesome!
Author:  zooky08 [ Wed Feb 20, 2013 7:29 pm ]
Post subject:  Re: NT Diff ratio 1L Transfer ratio
barlow wrote:
Thanks. Also The wt and nt axle splines are they the same? So I can use a nt diff center in a wt diff housing with the wt axles?

Only a nt 1.3 center you can. 1l nt center will not fit.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/