[macguyverjimny]

Hi guys,

Can someone post to me some pics of a new caster correction radius arms nextb to the standard radius arms for a 3 inch lift like from jimnybits,

I measured the distace of the three mounting point at my current setup, and then i jacked up the car 75 mm. (just the chassis)

So know i got both set of measurements ,

I did some drawings on cad , but the centre of the new holes in the new radius arms are not that different from the standard arms.


Any help would be appreciated thank you.

[macguyverjimny]

Here is my drawing, the new radius arm is on front, please ignore the general design just look at the angle to move the axle in the right place.

[Gwagensteve]

That looks bout right. How many degrees did you roll the mounts?

Steve.

[JayKay]

Here dude,

hope this helps

[BertZook]

there are some pics on ppls built treads, dont remember who so wait till someone reads in here.

also if I not wrong the jimnybits arms and also the ORA ones move the axle forward a bit too to return it to his original position but with the lift.... something you can consider too while you are there making some drawings

[suzkboy]

Yeah I have jimny bits arms in my car and they push the diff forward as well as fix the angle.

[macguyverjimny]

hi guys , thanx for the comments, that is about 2.7 degrees anti clockwise.

I willtake the radius arm off the car to make a more accurate drawing .

I also need to measure the back so that is still to come....

Thanx