Here is my drawing, the new radius arm is on front, please ignore the general design just look at the angle to move the axle in the right place.
| auszookers.com http://auszookers.com/forum/ |
|
| Radius arms. http://auszookers.com/forum/viewtopic.php?f=5&t=40008 |
Page 1 of 1 |
| Author: | macguyverjimny [ Wed Apr 03, 2013 8:47 am ] |
| Post subject: | Radius arms. |
Hi guys, Can someone post to me some pics of a new caster correction radius arms nextb to the standard radius arms for a 3 inch lift like from jimnybits, I measured the distace of the three mounting point at my current setup, and then i jacked up the car 75 mm. (just the chassis) So know i got both set of measurements , I did some drawings on cad , but the centre of the new holes in the new radius arms are not that different from the standard arms. Any help would be appreciated thank you. |
|
| Author: | macguyverjimny [ Wed Apr 03, 2013 9:09 am ] |
| Post subject: | Re: Radius arms. |
Here is my drawing, the new radius arm is on front, please ignore the general design just look at the angle to move the axle in the right place.
|
|
| Author: | Gwagensteve [ Wed Apr 03, 2013 9:18 am ] |
| Post subject: | Re: Radius arms. |
That looks bout right. How many degrees did you roll the mounts? Steve. |
|
| Author: | JayKay [ Wed Apr 03, 2013 10:29 am ] |
| Post subject: | Re: Radius arms. |
Here dude, hope this helps 
|
|
| Author: | BertZook [ Wed Apr 03, 2013 10:31 am ] |
| Post subject: | Re: Radius arms. |
there are some pics on ppls built treads, dont remember who so wait till someone reads in here. also if I not wrong the jimnybits arms and also the ORA ones move the axle forward a bit too to return it to his original position but with the lift.... something you can consider too while you are there making some drawings 
|
|
| Author: | suzkboy [ Wed Apr 03, 2013 1:37 pm ] |
| Post subject: | Re: Radius arms. |
Yeah I have jimny bits arms in my car and they push the diff forward as well as fix the angle. |
|
| Author: | macguyverjimny [ Wed Apr 03, 2013 3:14 pm ] |
| Post subject: | Re: Radius arms. |
hi guys , thanx for the comments, that is about 2.7 degrees anti clockwise. I willtake the radius arm off the car to make a more accurate drawing . I also need to measure the back so that is still to come.... Thanx 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|