| auszookers.com http://auszookers.com/forum/ |
|
| Sierra wiring diagram http://auszookers.com/forum/viewtopic.php?f=5&t=40132 |
Page 1 of 1 |
| Author: | Critical Energy [ Mon Apr 08, 2013 6:57 pm ] |
| Post subject: | Sierra wiring diagram |
Howdy all, Does anyone have a wiring diagram for a sierra with G16B? Doing a bit of a cabin overhaul and will need to replace a fair bit of wiring so thought I might chuck any extra wiring I might need in there at the same time "just in case" (thats for the benefit of Mrs Critical Energy) Rich |
|
| Author: | shark [ Mon Apr 08, 2013 8:50 pm ] |
| Post subject: | Re: Sierra wiring diagram |
What car is it from.. The 16b. Originally |
|
| Author: | want33s [ Tue Apr 09, 2013 9:32 am ] |
| Post subject: | Re: Sierra wiring diagram |
When you fit a G16B to a Sierra there are only 4 wires that need to integrate into the original loom (assuming you are using a cleaned up Vit/Baleno loom). Ignition power. Tacho feed. Fuel pump. Earth. Just run them when you do the engine install. |
|
| Author: | Critical Energy [ Tue Apr 09, 2013 4:59 pm ] |
| Post subject: | Re: Sierra wiring diagram |
Thanks guys, in that case i'll forget about it until the (possible) engine swap, however, does anyone have a standard wiring diagram? '84 LWB Ute, 1.0litre 4speed. Reason being that a lot of things don't work in mine, looks like a few things were chopped out previously, things like fuel gauge, engine temp, hand brake on, and what appears to be a 4x4 selected light thats been painted over black. Rich |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|