| auszookers.com http://auszookers.com/forum/ |
|
| Can you adjust valve springs on jimny? http://auszookers.com/forum/viewtopic.php?f=5&t=41365 |
Page 1 of 1 |
| Author: | sjzook [ Tue Jun 11, 2013 7:43 pm ] |
| Post subject: | Can you adjust valve springs on jimny? |
Hey guys I'm looking at buying a jimny, the guy says it had rebuild 2-3000kms ago, he is saying it needs the valves tightened now it has been run in, im a motorbike fan and normally adjust shims on them etc, but as far as I was aware you can't tighten or adjust on the cars? Or am I being a noob etc. thanks guys |
|
| Author: | atari4x4 [ Tue Jun 11, 2013 7:47 pm ] |
| Post subject: | Re: Can you adjust valve springs on jimny? |
what engine? |
|
| Author: | sjzook [ Tue Jun 11, 2013 8:07 pm ] |
| Post subject: | Re: Can you adjust valve springs on jimny? |
Noisy top end after rebuild, could be tappets or valves, g13bb 99 jimny |
|
| Author: | 2stroker [ Tue Jun 11, 2013 9:25 pm ] |
| Post subject: | Re: Can you adjust valve springs on jimny? |
Most motorcycles are adjusted with shims most cars are adjusted more easily with a lock nut and screwdriver or Allen key. |
|
| Author: | atari4x4 [ Tue Jun 11, 2013 9:39 pm ] |
| Post subject: | Re: Can you adjust valve springs on jimny? |
M13a are done with shims, along with alot of modern motors. the g13bb would be the old feeler gauge, spanner & screw driver technique. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|