Ok so I put a g16b baleno motor in my Sierra
. ..
so how do I go about reporting it to main roads qld ???The car was allready mod plated for a g16a.(carby)
| auszookers.com http://auszookers.com/forum/ |
|
| new engine compliance http://auszookers.com/forum/viewtopic.php?f=5&t=44274 |
Page 1 of 1 |
| Author: | KEENSY85 [ Thu Dec 12, 2013 5:43 am ] |
| Post subject: | new engine compliance |
Ok so I put a g16b baleno motor in my Sierra . .. so how do I go about reporting it to main roads qld ???The car was allready mod plated for a g16a.(carby) |
|
| Author: | Rusho [ Thu Dec 12, 2013 6:01 am ] |
| Post subject: | Re: new engine compliance |
Assuming the mod plate is the same code just tell them you blew up the old engine and replaced it, all you should have to give them is the new engine number. |
|
| Author: | KEENSY85 [ Thu Dec 12, 2013 7:15 am ] |
| Post subject: | Re: new engine compliance |
Thats what im hopeing 
|
|
| Author: | droverdave [ Thu Dec 12, 2013 12:03 pm ] |
| Post subject: | Re: new engine compliance |
What is the code on the mod plate arleady? |
|
| Author: | Rossco [ Thu Dec 12, 2013 12:19 pm ] |
| Post subject: | Re: new engine compliance |
can you just ring up and give them the new number or does it have to be sighted by going over the pits? |
|
| Author: | henno [ Thu Dec 12, 2013 12:38 pm ] |
| Post subject: | Re: new engine compliance |
I changed my engine number once and QLD Transport simply walked out and looked at it in the carpark and made sure the number matched. |
|
| Author: | tanshi [ Thu Dec 12, 2013 1:04 pm ] |
| Post subject: | Re: new engine compliance |
if you do it on a rainy day they will just take your word for it 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|