Should they not be held on by door clips?
A flat blade between metal and plyboard, and gently prise.
2 scrapers, one each side of the clip, for added safety
| auszookers.com http://auszookers.com/forum/ |
|
| Lj81 door restoration http://auszookers.com/forum/viewtopic.php?f=5&t=46426 |
Page 1 of 1 |
| Author: | Mickslj81 [ Wed May 28, 2014 12:01 pm ] |
| Post subject: | Lj81 door restoration |
Anyone know the best way to pull the vinal covered plyboard inner door trim off? Have got everything unbolted except the window winder handle and am looking for the best way to remove it without damaging it? Thanks mick |
|
| Author: | 1DYX [ Wed May 28, 2014 2:26 pm ] |
| Post subject: | Re: Lj81 door restoration |
Should they not be held on by door clips? A flat blade between metal and plyboard, and gently prise. 2 scrapers, one each side of the clip, for added safety
|
|
| Author: | 1DYX [ Wed May 28, 2014 2:32 pm ] |
| Post subject: | Re: Lj81 door restoration |
Just re-read. Window winder as well? From memory, it has a little pin that just pushes out when you lever the soft plastic surround back. Or do they use the circlip? been so long.. |
|
| Author: | sideways [ Wed May 28, 2014 10:10 pm ] |
| Post subject: | Re: Lj81 door restoration |
Yep, little pin. You fold the rubber surround thingy back and push the pin out, then the handle slides off. Mark which way it went on so you get it in the right spot again. 
|
|
| Author: | Mickslj81 [ Thu May 29, 2014 11:42 am ] |
| Post subject: | Re: Lj81 door restoration |
Gotit off in about thirty seconds thanksguys |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|