| auszookers.com http://auszookers.com/forum/ |
|
| 1.6 carby conversion http://auszookers.com/forum/viewtopic.php?f=5&t=46533 |
Page 1 of 1 |
| Author: | sj70zuki [ Thu Jun 05, 2014 5:51 pm ] |
| Post subject: | 1.6 carby conversion |
what needs to be done on 1.6 conversion into sierra is there any links to someone that has already done one? |
|
| Author: | Dec [ Thu Jun 05, 2014 7:37 pm ] |
| Post subject: | Re: 1.6 carby conversion |
They're plenty of people who have done this conversion, I for one. My advise would be to purchase BenT's kit it will include everything you need plus instructions (Minus motor etc.). viewtopic.php?f=15&t=15009 Here's the search area if you'd like to look yourself search.php The hardest part of the conversion will be swapping your oil pick up off your current g13 onto the g16a plus you may need to 'massage' your g13 sump to fit onto the g16a with it's new pick-up It's a very simple conversion with minor headaches, here are a few items that you will run into Starter motor body may need grinding down to fit Clutch cable will need spacing The motor will sit higher so either spacing of the bonnet or body-lift Air intake will be on opposite side if you use the g16a carby+intake I hope this helps with your conversion and if I've forgotten anything please add to it:) Good luck with your conversion! |
|
| Author: | sj70zuki [ Fri Jun 06, 2014 4:34 am ] |
| Post subject: | Re: 1.6 carby conversion |
How is the pick up swapped and by 'massage' what do you mean |
|
| Author: | sj70zuki [ Fri Jun 06, 2014 4:36 am ] |
| Post subject: | Re: 1.6 carby conversion |
I whsnt to be abe to do this in a weekend is there and one in the childers or bundy area able to help? |
|
| Author: | Dec [ Fri Jun 06, 2014 9:43 pm ] |
| Post subject: | Re: 1.6 carby conversion |
Cut and weld the pick-up and by 'massage' i mean using a hammer on the sump. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|