[suzukikid]

Hey all I have searched but all I can find is that the bolt patterns are different...

Cut a long story short I have a wt... My front shaft has heaps of play in the spline.... I have a good nt shaft here! Can I pull them both apart and put new unis in and use the end bits off the wt on the nt shaft?

Only reason I ask is I was flicking threw eBay and a uni for up 1987 came up that's a lot cheaper.... So thought maybe they are different?

[jdk81]

Yes they swap over and use the same unis

[sideways]

1l is different though, check it's not a 1l one.

[MrRocky]

Beware most circlips you get with new unis dont fit right and an pop out.
I normally try to reuse the factory ones where possible

[Bruce]

MrRocky wrote:

Beware most circlips you get with new unis dont fit right and an pop out.
I normally try to reuse the factory ones where possible

Soooooooooo true.

[suzukikid]

Ok thanks guys!