| auszookers.com http://auszookers.com/forum/ |
|
| Nt and wt take the same uni? http://auszookers.com/forum/viewtopic.php?f=5&t=46554 |
Page 1 of 1 |
| Author: | suzukikid [ Mon Jun 09, 2014 8:35 am ] |
| Post subject: | Nt and wt take the same uni? |
Hey all I have searched but all I can find is that the bolt patterns are different... Cut a long story short I have a wt... My front shaft has heaps of play in the spline.... I have a good nt shaft here! Can I pull them both apart and put new unis in and use the end bits off the wt on the nt shaft? Only reason I ask is I was flicking threw eBay and a uni for up 1987 came up that's a lot cheaper.... So thought maybe they are different? |
|
| Author: | jdk81 [ Mon Jun 09, 2014 8:50 am ] |
| Post subject: | Re: Nt and wt take the same uni? |
Yes they swap over and use the same unis |
|
| Author: | sideways [ Mon Jun 09, 2014 9:35 am ] |
| Post subject: | Re: Nt and wt take the same uni? |
1l is different though, check it's not a 1l one. |
|
| Author: | MrRocky [ Mon Jun 09, 2014 11:30 am ] |
| Post subject: | Re: Nt and wt take the same uni? |
Beware most circlips you get with new unis dont fit right and an pop out. I normally try to reuse the factory ones where possible |
|
| Author: | Bruce [ Mon Jun 09, 2014 12:17 pm ] |
| Post subject: | Re: Nt and wt take the same uni? |
MrRocky wrote: Beware most circlips you get with new unis dont fit right and an pop out. I normally try to reuse the factory ones where possible Soooooooooo true. |
|
| Author: | suzukikid [ Mon Jun 09, 2014 3:24 pm ] |
| Post subject: | Re: Nt and wt take the same uni? |
Ok thanks guys! |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|