| auszookers.com http://auszookers.com/forum/ |
|
| Re-installing 1999 Jimny engine & gearbox http://auszookers.com/forum/viewtopic.php?f=5&t=46695 |
Page 1 of 1 |
| Author: | BigRay [ Fri Jun 20, 2014 7:32 pm ] |
| Post subject: | Re-installing 1999 Jimny engine & gearbox |
I will soon be re-installing a reconditioned engine and reconditioned gearbox into my Jimny. After battling getting the gearbox out past the exhaust mount (chassis) I was wondering if it is possible re-install the engine and gearbox together through the engine bay, but thinking that mount may become a problem again. I am not considering cutting the mount off and I won't. It is a manual transmission with G13BB engine. Ray |
|
| Author: | BigRay [ Fri Jun 20, 2014 7:33 pm ] |
| Post subject: | Re: Re-installing 1999 Jimny engine & gearbox |
Still haven't got the gearbox out btw. Sitting on a jack under the car at the moment. Got the clutch out though. |
|
| Author: | russty_2008 [ Sat Jun 21, 2014 7:54 pm ] |
| Post subject: | Re: Re-installing 1999 Jimny engine & gearbox |
If you take the bracket off the back of the gearbox that holds your gear stick it will go back in easy |
|
| Author: | BigRay [ Sat Jun 21, 2014 9:07 pm ] |
| Post subject: | Re: Re-installing 1999 Jimny engine & gearbox |
Yeah all brackets are off, just the bare lump of aluminium. Might just be one of those tricky things. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|