[Sutho]

Hey gang!
I'm doing a G16b conversion ATM and I'm also doing powersteering on it!
I'm having a problem with the lines
I will need to get custom ones made

Who makes them around brisbane?
Do I need to supply the fittings?
Also! I have a flared loose nut fitting that goes on the box end return line, but in the box there is no flare in it to screw down onto! What the?

[ajsr]

you can do the conversion using all the vit lines, but the are a little too wide in the steel section and you need to get a little creative.
otherwise any hydraulics shop can make custom lines for you.

[lbzook]

^^^agreed, just take you high pressure hose to a hydraulic shop and get them to put the fittings onto a soft line whatever length you need.

[Sutho]

Have you guys got any info or pics on the fitting in the powersteering box? Return line one

[lbzook]

Not on hand, I can get some tomorrow arvo if no one else has any handy

[Sutho]

I need the brass concave fitting the return line flared fitting tightens down on

[Sutho]

Convex sorry

[lbzook]

I had a look at mine today, couldn't see down into the return line fitting properly, too much p/s fluid around. From memory though, I don't think that there was a separate fitting in there at all. Just tighten the return line on and away you go.