auszookers.com
http://auszookers.com/forum/

Lj81, f8a to f10a wiring problem
http://auszookers.com/forum/viewtopic.php?f=5&t=47496		 Page 1 of 1
Author:  ko2_koko [ Fri Aug 22, 2014 4:32 pm ]
Post subject:  Lj81, f8a to f10a wiring problem
I'm doing a engine swap for a mate. Got the f8a out and the f10 in, no problems there. got it cranking, fuel and all that jazz.
The thing I'm missing is spark. The f10 is our of a carrier and I can't get the coil to send power to the dizzy. Any help would be great guys
Author:  sideways [ Fri Aug 22, 2014 5:02 pm ]
Post subject:  Re: Lj81, f8a to f10a wiring problem
Swap to the LJ dizzy, F10a one will leak anyway.
Author:  ko2_koko [ Fri Aug 22, 2014 5:44 pm ]
Post subject:  Re: Lj81, f8a to f10a wiring problem
I would but that motors gone now, why they leak?? Because the angle of the motor?
Author:  303zuke [ Fri Aug 22, 2014 8:19 pm ]
Post subject:  Re: Lj81, f8a to f10a wiring problem
Did you keep the Carry dizzy housing and dizzy intact when you did the swap?

There's no reason why the engine shouldn't fire with the Carry Dizzy/ LJ Coil combo unless you've upset the timing. I presume you haven't disconnected the coil low tension wires and reversed them, and that you have retained the ballast resistor. Recheck the dizzy timing. If you have the rotor going to No1 plug at TDC and it won't fire, it could be out of phase 180deg.

Which tip did you dump the F8A?
Author:  ko2_koko [ Sat Aug 23, 2014 7:22 pm ]
Post subject:  Re: Lj81, f8a to f10a wiring problem
Haven't touched the dizzy or wires on it. Think he sold the f8a. The coil isn't putting any power out of it when I put a test light on it. I have a earth running from the block to the coil then 2 wires running out of the loom to the coil. Does this sound right?
Author:  JrZook [ Sat Aug 23, 2014 9:06 pm ]
Post subject:  Re: Lj81, f8a to f10a wiring problem
ko2_koko wrote:
I have a earth running from the block to the coil then 2 wires running out of the loom to the coil. Does this sound right?

Nope!
The coil should have +12V to the coil (+) terminal. This will come either directly or through a ballast resistor from the key barrel with the ignition in the "ign" and "start" positions. The ballast resistor may be bypassed in the "start" position. Therefore you could have a maximum of 2 wires going to the coil (+). Test these wires with your node light in respect to the negative battery terminal to make sure you have power on them. The coil (-) terminal goes to the points distributor which is linked to the engine block and should be connected to the negative battery terminal
Author:  ko2_koko [ Mon Aug 25, 2014 5:20 pm ]
Post subject:  Re: Lj81, f8a to f10a wiring problem
Cheers guys, she is tuning like a champ
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/