auszookers.com
http://auszookers.com/forum/

Mounting light bar on Jimny roof
http://auszookers.com/forum/viewtopic.php?f=5&t=47550		 Page 1 of 1
Author:  honour [ Tue Aug 26, 2014 8:41 pm ]
Post subject:  Mounting light bar on Jimny roof
Hey guys,
I have a lightbar which is to be mounted to my roof basket shortly, however I am unsure as to how people have wired theirs.
Was thinking of running a new line down with the aerial, or perhaps through the foot of the roof rails.
Anyone know a better way?
Cheers!
Author:  Mike57 [ Tue Aug 26, 2014 8:59 pm ]
Post subject:  Re: Mounting light bar on Jimny roof
Take a look through Zukenutters build thread. He has ended up with a cable gland through the roof.

Something like this one.

http://www.ebay.com.au/itm/150957283432 ... 1423.l2649
Author:  honour [ Tue Aug 26, 2014 9:56 pm ]
Post subject:  Re: Mounting light bar on Jimny roof
Yeh from memory he drilled a hole through the roof - not 100% keen on that path. Mostly because I know I will mess it up somehow. Haha.
Author:  Dan85 [ Wed Aug 27, 2014 7:21 am ]
Post subject:  Re: Mounting light bar on Jimny roof
I ran mine up the drivers side on the windscreen in a temp plastic stick on duct from bunnings. Works well and looks neat enough and isn't permanent.
Author:  honour [ Wed Aug 27, 2014 9:35 am ]
Post subject:  Re: Mounting light bar on Jimny roof
Cool, thanks Dan. Might look at coming up with something similar. Thanks mate!
Author:  pete_79 [ Wed Aug 27, 2014 9:45 am ]
Post subject:  Re: Mounting light bar on Jimny roof
I'm sure you could use your snorkel to hide most of the conduit. It would just be the last bit from the top snorkel bracket to the antenna that would be most obvious.
Author:  honour [ Wed Aug 27, 2014 10:08 am ]
Post subject:  Re: Mounting light bar on Jimny roof
That was another thought I had Pete. I read of people even putting it inside the snorkel, but I think drilling holes in the top and bottom to run the cable sort of defeats the purpose of having the snorkel in the first place. Haha.
Author:  31zook [ Wed Aug 27, 2014 12:16 pm ]
Post subject:  Re: Mounting light bar on Jimny roof
This is what I did.

Only mod the antenna to fit the cabling.

Image
Author:  honour [ Wed Aug 27, 2014 1:21 pm ]
Post subject:  Re: Mounting light bar on Jimny roof
Perfect! Thats exactly that I was thinking of. Especially with the disconnect.
Author:  zukenutter [ Wed Aug 27, 2014 9:05 pm ]
Post subject:  Re: Mounting light bar on Jimny roof
My plug style gland is still leak free but I should have just done the antenna hole, so much simpler.
Author:  NickCooper [ Thu Aug 28, 2014 9:19 pm ]
Post subject:  Re: Mounting light bar on Jimny roof
I saw a light bar mounted on a Jimny roof in a car yard. The wiring had been run down the hinged side of the back door and then in behind the tail light
Author:  NickCooper [ Thu Aug 28, 2014 9:24 pm ]
Post subject:  Re: Mounting light bar on Jimny roof
Image
Image
Image
Goes into the rubber boot behind the tail light
Author:  honour [ Thu Aug 28, 2014 9:36 pm ]
Post subject:  Re: Mounting light bar on Jimny roof
Certainly an interesting approach. I would be worried about running the conduit from the rail foot over the roof into the cavity - although only a small run, I think it would look quite ugly to be honest.
Thank you so much for the photos - I hope you didn't stop just to get photos for this thread. Haha.
Author:  NickCooper [ Fri Aug 29, 2014 6:05 am ]
Post subject:  Re: Mounting light bar on Jimny roof
No worries. I took these pics about 2-3 months ago. I'm going to do the same for my Jimny. (Have a custom roof basket, no rails). I have two light bars mounted to my roof now, just not wired up
Author:  zukenutter [ Fri Aug 29, 2014 7:14 am ]
Post subject:  Re: Mounting light bar on Jimny roof
I had my old Jimny roof lights wired similarly to this ^^. Worked fine but voltage drop may be an issue with such a long path.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/