sure it's not the CV binding?
here's an idea, get lockers & stop chasing needless flex.
| auszookers.com http://auszookers.com/forum/ |
|
| Steering arm point change - Can It be done? http://auszookers.com/forum/viewtopic.php?f=5&t=47640 |
Page 1 of 1 |
| Author: | NomadGV03 [ Tue Sep 02, 2014 5:47 pm ] |
| Post subject: | Steering arm point change - Can It be done? |
I was wondering if it was possible to mount the arm on top with drilling out the hole a little bit bigger for the tapered bolt to fit through for less issues with full-flex steering? |
|
| Author: | atari4x4 [ Tue Sep 02, 2014 5:58 pm ] |
| Post subject: | Re: Change steering arm point change - Can It be done? |
Why? Not concerned about it binding on compression? |
|
| Author: | NomadGV03 [ Tue Sep 02, 2014 6:07 pm ] |
| Post subject: | Re: Change steering arm point change - Can It be done? |
Locks up when the wheel is in the air |
|
| Author: | atari4x4 [ Tue Sep 02, 2014 6:08 pm ] |
| Post subject: | Re: Change steering arm point change - Can It be done? |
sure it's not the CV binding? here's an idea, get lockers & stop chasing needless flex.
|
|
| Author: | NomadGV03 [ Tue Sep 02, 2014 6:22 pm ] |
| Post subject: | Re: Steering arm point change - Can It be done? |
I love flex  Trying to make the most out of the control arms. Might be the CV's.I have new steering rods and will take it into the alignment place to see what they can do when they fit them. |
|
| Author: | atari4x4 [ Tue Sep 02, 2014 6:33 pm ] |
| Post subject: | Re: Steering arm point change - Can It be done? |
|
|
| Author: | got_bar_work [ Tue Sep 02, 2014 6:41 pm ] |
| Post subject: | Re: Steering arm point change - Can It be done? |
U will have massive bump steer If they are binding u could drill out the taper to suite 80 tre U then will need to machine new long adjuster nuts that join the steering arms together |
|
| Author: | NomadGV03 [ Tue Sep 02, 2014 7:01 pm ] |
| Post subject: | Re: Steering arm point change - Can It be done? |
Also I found out that anything about a 28.5" (Total Dia) tyre on my GV isn't legal  - According to Tyrepower And I am about to buy some 31's 
|
|
| Author: | Zook_Fan [ Tue Sep 02, 2014 7:03 pm ] |
| Post subject: | Re: Steering arm point change - Can It be done? |
Yep bumpsteer will go up. Might be a small change in a straight line but a bumpy windy road will be terrible. |
|
| Author: | Gwagensteve [ Wed Sep 03, 2014 6:54 am ] |
| Post subject: | Re: Steering arm point change - Can It be done? |
^ these guys. Bumpity bumpsteer |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|