Damaged detent ball
| auszookers.com http://auszookers.com/forum/ |
|
| vitara box question http://auszookers.com/forum/viewtopic.php?f=5&t=5021 |
Page 1 of 1 |
| Author: | Fluffy [ Sun May 31, 2009 1:26 am ] |
| Post subject: | vitara box question |
transferred my good box and motor into my good vit... (has run 10 000 k without a hitch) the box has decided not to smoothly select out of 1st and second. it wont push into 3-4-5-and r only yesterday it was running fine .. is this a common prob or am i in big trouble... I'm gunna consult Manuel and see what he says just wondering if anyone had any ideas? thanks Fluff |
|
| Author: | steve [ Sun May 31, 2009 1:31 am ] |
| Post subject: | Re: vitara box question |
not something simple like the usual sierra issue of stuffed gear stick bushes? |
|
| Author: | Fluffy [ Sun May 31, 2009 1:43 am ] |
| Post subject: | Re: vitara box question |
it does go over to the 3-4 slot but its hard, and it does go into 5-r but its harder. feels like its stuck |
|
| Author: | kenn [ Sun May 31, 2009 12:38 pm ] |
| Post subject: | Re: vitara box question |
Damaged detent ball
|
|
| Author: | royce [ Sun May 31, 2009 8:38 pm ] |
| Post subject: | Re: vitara box question |
hard with engine off or hard with running and foot on clutch? |
|
| Author: | Fluffy [ Sun May 31, 2009 9:08 pm ] |
| Post subject: | Re: vitara box question |
both |
|
| Author: | royce [ Sun May 31, 2009 9:27 pm ] |
| Post subject: | Re: vitara box question |
got the stick in properly? its pretty easy to think its on right but isnt |
|
| Author: | joeblow [ Sun May 31, 2009 9:36 pm ] |
| Post subject: | Re: vitara box question |
if the stick is in right it will be either a clutch, pressure plate or cable problem. your firewall is not cracked? |
|
| Author: | Fluffy [ Sun May 31, 2009 11:24 pm ] |
| Post subject: | Re: vitara box question |
found it.. while removing box from donor.. the bush found its way behind the gear shift arm. when it was installed in the recipient. i had the bush from the previous box on the dash.. couldn't see it will i removed the shift lever case... and dismantled it. ughh *headbutts wall* all good now cheers fellas |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|