| auszookers.com http://auszookers.com/forum/ |
|
| Replacement G16A needed http://auszookers.com/forum/viewtopic.php?f=5&t=5029 |
Page 1 of 1 |
| Author: | Jester [ Mon Jun 01, 2009 12:21 am ] |
| Post subject: | Replacement G16A needed |
Ok I've got the head off my vitara, and it appears ill be looking for another engine or a full rebuild, cos there is a nice ridge around the bores half way up, I live around Adelaide do any of you other locals point me in the direction of a reputable suzuki wrecker, or a private engine. Another suggestion a mat had was to get a Vitara front cut (could be an EFI one then) and do the swap over as I'm also gonna be looking at swapping out the auto for a manual in the near future. Would there be anywhere around adelaide that would do a vitara half cut? and what sort of price would they charge? |
|
| Author: | want33s [ Mon Jun 01, 2009 12:55 am ] |
| Post subject: | Re: Replacement G16A needed |
try www.adeljap.com.au for a front cut. Jas. |
|
| Author: | Damo [ Mon Jun 01, 2009 1:43 am ] |
| Post subject: | Re: Replacement G16A needed |
If you end up getting a replacement engine let me know if you want to sell that block. |
|
| Author: | Jester [ Mon Jun 01, 2009 2:05 am ] |
| Post subject: | Re: Replacement G16A needed |
Damo wrote: If you end up getting a replacement engine let me know if you want to sell that block.
well Ill talk to my boss about the engines state and see what he suggests I do, But if i dont end up using it you would be welcome to buy it, (sorry i changed my tune a bit but i talk crap when im overtired and pissed off) |
|
| Author: | Polar_Bear [ Tue Jun 02, 2009 4:15 am ] |
| Post subject: | Re: Replacement G16A needed |
I reckon you would be hard pressed to find a half cut vit in adelaide at a reasonable cost? i got one from sydney a couple of years ago for 1600 bucks, i did have a good g16A but sold it to chop! ive still got a 5sp manual if you want to swap out ya auto...i'm swaping in an auto 
|
|
| Author: | Jester [ Tue Jun 02, 2009 11:44 am ] |
| Post subject: | Re: Replacement G16A needed |
Polar_Bear wrote: I reckon you would be hard pressed to find a half cut vit in adelaide at a reasonable cost? i got one from sydney a couple of years ago for 1600 bucks, i did have a good g16A but sold it to chop! ive still got a 5sp manual if you want to swap out ya auto...i'm swaping in an auto
yeah for sure i would PM sent |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|