| auszookers.com http://auszookers.com/forum/ |
|
| Water pipe seal to pump size http://auszookers.com/forum/viewtopic.php?f=5&t=55215 |
Page 1 of 1 |
| Author: | Tuftruk2 [ Tue May 29, 2018 7:54 am ] |
| Post subject: | Water pipe seal to pump size |
About to replace the o ring seal with instal of new water pipe to rear of water pump. Want to replace old seal but not sure of size. Anyone know the specifics of what o ring I need to buy?? |
|
| Author: | AckerDackerly [ Thu May 31, 2018 1:54 am ] |
| Post subject: | Re: Water pipe seal to pump size |
Which engine are you referring to? I would assume that you are talking about the 1.3, but assuming is a dangerous thing. I read the specifications on the 1,3 "O" ring seal somewhere very recently. Hopefully I can find it again for you... |
|
| Author: | AckerDackerly [ Thu May 31, 2018 2:01 am ] |
| Post subject: | Re: Water pipe seal to pump size |
Here is a link to the O-ring as sold by Low Range Offroad (priced in Australain dollars): http://www.lowrangeoffroad.com/samurai- ... oring.html I hope that this helps! |
|
| Author: | bumstein [ Thu May 31, 2018 3:16 pm ] |
| Post subject: | Water pipe seal to pump size |
You might just find that ordering it from Low Range Offroad will cost a huge amount in shipping. I was recently going to order some outer free wheeling hug seals and although they were 5-10 bucks to buy the seal, shipping was something like 55 clams. Compare the price with megazip.net, price including shipping will likely be cheaper. Another alternative is take the old one to Statewide Bearings (or whatever is near you) or a hydraulic place. They might just have something that will work for bugger all cost |
|
| Author: | Gwagensteve [ Thu May 31, 2018 4:20 pm ] |
| Post subject: | Re: Water pipe seal to pump size |
Yep- it’s just an O ring. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|