| auszookers.com http://auszookers.com/forum/ |
|
| Carby to injected motor http://auszookers.com/forum/viewtopic.php?f=5&t=56043 |
Page 1 of 1 |
| Author: | 0359mcculloch [ Sun Sep 22, 2019 4:50 pm ] |
| Post subject: | Carby to injected motor |
Have a g16a carby engine in a vitara and wondering can I fit a g16b efi motor in its place using carby etc !!!! Different I know !! appreciate any advise !! |
|
| Author: | jdk81 [ Mon Sep 23, 2019 1:57 pm ] |
| Post subject: | Re: Carby to injected motor |
There has been a few people use carbies on the g16b motors etc. IMO its mostly pointless. If you want EFI in your car find a g16b with loom etc and install it. |
|
| Author: | 0359mcculloch [ Mon Sep 23, 2019 4:47 pm ] |
| Post subject: | Re: Carby to injected motor |
Just looking as an engine swap not for any gains !!!! |
|
| Author: | saph [ Mon Sep 23, 2019 6:28 pm ] |
| Post subject: | Re: Carby to injected motor |
defently if its the same year and matches up bolt hole wise between the engines, plenty of folk here cram a g16b into sierra's. |
|
| Author: | Eddy [ Tue Sep 24, 2019 7:37 am ] |
| Post subject: | Re: Carby to injected motor |
My initial thoughts are that it may be more of a headfuck to change over to carby than to fit the extra bits in to run the efi? |
|
| Author: | bumstein [ Tue Sep 24, 2019 10:24 am ] |
| Post subject: | Re: Carby to injected motor |
If the manifold bolt patterns are the same I don’t see any reason it would be difficult, I can’t confirm the bolt patters are the same sorry |
|
| Author: | MrRocky [ Tue Sep 24, 2019 12:13 pm ] |
| Post subject: | Re: Carby to injected motor |
Exhaust on the 16v head is different from memory |
|
| Author: | Gwagensteve [ Tue Sep 24, 2019 12:15 pm ] |
| Post subject: | Re: Carby to injected motor |
Manifold patterns are not the same. Jonno-Racing built a carby G16b. It worked well but required custom work to run a suitable distributor and a custom inlet manifold to use twin sidedraft pit bike carbs. There is a TBI swift that could supply a downdraft compatible manifold, but distributor etc will still need to be dealt with. All up a lot of fiddly work to have none of the benefits of efi (which has nothing to do with gains- it’s all about reliability, drivability and diagnostics) |
|
| Author: | 303zuke [ Thu Sep 26, 2019 6:10 am ] |
| Post subject: | Re: Carby to injected motor |
Gwagensteve wrote: There is a TBI swift that could supply a downdraft compatible manifold, ......... The Swift has the engine in an East/West configuration, and the block is rotated forward to clear the bonnet. The Swift manifold on the 16v 1.6 can be used in a Nth/Sth RWD configuration as EFi, but when used with a Carby it would be tilted to the driver's side, playing havoc with the float. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|