| auszookers.com http://auszookers.com/forum/ |
|
| Vibration issues http://auszookers.com/forum/viewtopic.php?f=5&t=56096 |
Page 1 of 1 |
| Author: | Vitaralad [ Mon Oct 28, 2019 11:46 am ] |
| Post subject: | Vibration issues |
All guys, so I jacked up my 95 swb vitara three inches. Now I’m having an issue with some vibrations lightly on and off the accelerator. (Starts around 50kph) everything in the front end is brand new besides the idler arm. Now in the rear end I have new unis and drive shaft. Drive shaft was balanced earlier today however I am getting the same vibrations. I understand that my drive shaft and unis are at an angle where they have a fair bit of pressure on them, however I have spoken to a few people who have no issues with the same lift and angle. So I’m curious as to whether I’ve got an issue with the rear diff or transfer case and if anyone here has had the same problem and how they fixed it. |
|
| Author: | Gwagensteve [ Mon Oct 28, 2019 5:01 pm ] |
| Post subject: | Re: Vibration issues |
Needs a driveshaft spacer. 3” of lift over extends the slip yoke. |
|
| Author: | Vitaralad [ Mon Oct 28, 2019 5:05 pm ] |
| Post subject: | Re: Vibration issues |
Gwagensteve wrote: Needs a driveshaft spacer. 3” of lift over extends the slip yoke. Have the spacer mate, ball joint spacer too. |
|
| Author: | Vitaralad [ Mon Oct 28, 2019 6:35 pm ] |
| Post subject: | Re: Vibration issues |
I have the spacer. Would a car den shaft do the job? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|