auszookers.com
http://auszookers.com/forum/

free WTsierra chasis and tub.
http://auszookers.com/forum/viewtopic.php?f=7&t=17451		 Page 1 of 1
Author:  Built4thrashing [ Sun Dec 12, 2010 2:02 am ]
Post subject:  free WTsierra chasis and tub.
Got a free chasis and tub from my zook i want gone. Can have it for free.

tub still has dash and heater box etc. chasis has brake lines and fuel lines on it.


Pick up only.


B4T
Author:  foolsp33d [ Sun Dec 12, 2010 3:59 am ]
Post subject:  Re: free WTsierra chasis and tub.
tempting to take the tub and make another trailer Jase!!!! Will suze hit the roof if I come round with a plasma and snip it off at the B pillar and leave the front clip in the scrap heap!!? LOL hmmmmmm.. I think YES!!

Oh motor is in to :D just gota sort out the wires n crap ;) the dizzy on the 1298 has been rewired so thinking of swapping to the 1324 one.. know that one has new button n decent cap n seal ;)
Author:  Built4thrashing [ Sun Dec 12, 2010 7:32 am ]
Post subject:  Re: free WTsierra chasis and tub.
They are the same anyway.

You will not need a plasma cutter just a 4inch grinder with a good 1mm disc. thats how i did my last one. and while ya at it grab the rear end of the chasis for the frame. i have some old springs you could use. then you would only need to make a draw bar and get a solid axle from a trailer place.


B4T


B4T
Author:  foolsp33d [ Sun Dec 12, 2010 9:03 am ]
Post subject:  Re: free WTsierra chasis and tub.
oh yeh the dizzy is the same, just mine had all the matching plugs n crap.. pretty sure tis 180* out.. tunrs over great.. added some start ya bastard.. n she backfired.. so battery is on charge.. will investigate tomorrow with a timing light ;)

plasma is HEAPS more fun thou!

hmm tis pretty tempting to actually go through with this Jase!! using the rear half of the chasis might be a lil heavy.. I liked your way... Draw bar should be pretty simple.. got one of them 4 way hitches about someware to..
Gar why muct you tempt me so :(
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/