auszookers.com
http://auszookers.com/forum/

6 point internal rollcage to suit Sierra [WA]
http://auszookers.com/forum/viewtopic.php?f=7&t=18210		 Page 1 of 1
Author:  Red89 [ Thu Jan 13, 2011 7:27 am ]
Post subject:  6 point internal rollcage to suit Sierra [WA]
ITEM: 6 point internal rollcage to suit Sierra

PRICE AND PRICE CONDITIONS:700 ono

CONDITION: Used

REASON FOR SELLING: Change of plans am building a whole new cage from scratch for the new build.

EXTRA INFO: This cage is only twelve months old and has been involved in 3 rolls with no damage sustained at all, see vid. It has been made from 50mm tube, 2.5mm wall, has been built to meet CCDA regulations and has been signed off on by a CCDA scrutineer. It will fit any Sierra with a removable roof, however you will need to cut the dash a bit to fit it, see pics, it was done this way due to the regs and makes getting in and out easier, the rear of the cage also allows the use of the stock rear seats and the full roof. If a competent person did a cut and shut on it, it could be modded for a hard top. It comes with all the neccessary hardware and harness mounts, minus all the padding, which can be purchased at Clark Rubber and minus the spotties.

LOCATION: Perth WA

CONTACT: via Pm I am on here most nights

PICTURES/VID:

http://www.youtube.com/watch?v=bzXX8wys2Zc

Image
Image
Image
Image
Image
Image
Author:  Zooknoob [ Thu Jan 13, 2011 7:45 am ]
Post subject:  Re: 6 point internal rollcage to suit Sierra [WA]
That is a sexy looking Sierra you don't have any spare parts for sale?
Author:  YNV17 [ Thu Jan 13, 2011 7:48 am ]
Post subject:  Re: 6 point internal rollcage to suit Sierra [WA]
too bad ur in WA
Author:  93zook [ Thu Jan 13, 2011 8:31 am ]
Post subject:  Re: 6 point internal rollcage to suit Sierra [WA]
sent you a pm on ther other forum... :D
Author:  Red89 [ Thu Jan 13, 2011 8:40 am ]
Post subject:  Re: 6 point internal rollcage to suit Sierra [WA]
93zook wrote:
sent you a pm on ther other forum... :D

Sold pending payment :D
Author:  suzi-fan-22 [ Mon Jan 24, 2011 4:47 am ]
Post subject:  Re: 6 point internal rollcage to suit Sierra [WA]
quick question what is the od for that pipe and did it need toed to be squased to get next to the dash
Author:  Red89 [ Mon Jan 24, 2011 5:36 am ]
Post subject:  Re: 6 point internal rollcage to suit Sierra [WA]
OD is 50mm and the dash was cut to accomodate the tube to avoid squashing it or rerouting it in front of the dash.
Author:  Red89 [ Sun Jan 30, 2011 5:33 am ]
Post subject:  Re: 6 point internal rollcage to suit Sierra [WA]
SOLD!!
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/