auszookers.com
http://auszookers.com/forum/

Perth - Getting Rid of Old Gears
http://auszookers.com/forum/viewtopic.php?f=7&t=22269		 Page 1 of 1
Author:  Goldy [ Wed May 25, 2011 8:00 am ]
Post subject:  Perth - Getting Rid of Old Gears
I've just done 2 rebuilds so I have a bunch of left over components from a stock gear box.

Stock gears
Stock bearings
Speedo Driver Gear
Shafts
Thrust bearings
Small half of transfer case
+ more

Rather give it to someone on here then take it to the tip, let me know if you need anything and I'll have a look.
Author:  lyallrichards [ Wed May 25, 2011 9:29 am ]
Post subject:  Re: Perth - Getting Rid of Old Gears
im after ther gears plus the centre rod that holds the middle set of gears
and i live about 10 mins from your place

so give us a price
Author:  ChomperZook [ Mon May 30, 2011 9:27 am ]
Post subject:  Re: Perth - Getting Rid of Old Gears
do you have a 1.3 wt rear tailshaft by any chance?
Author:  Goldy [ Mon May 30, 2011 9:33 am ]
Post subject:  Re: Perth - Getting Rid of Old Gears
ChomperZook wrote:
do you have a 1.3 wt rear tailshaft by any chance?


na sorry mate, just whats inside the transfer case and n/t flanges
Author:  96coily [ Mon May 30, 2011 12:14 pm ]
Post subject:  Re: Perth - Getting Rid of Old Gears
Did you replace the Speedo Driver Gear to adjust the speed read out ??
if you did where did you get it from ???
Author:  Goldy [ Thu Jun 02, 2011 5:35 am ]
Post subject:  Re: Perth - Getting Rid of Old Gears
96coily wrote:
Did you replace the Speedo Driver Gear to adjust the speed read out ??
if you did where did you get it from ???


I did get a new Speedo Driver Gear from Suzistore, but I just had to replaced my stock 1 with another stock 1 because the teeth were chipped on it.
I've got to play around with it more once it's a finished project to get the speedo right again
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/