| auszookers.com http://auszookers.com/forum/ |
|
| Jimny Stuff: Body Lift, 3inch Springs, Gaurds. http://auszookers.com/forum/viewtopic.php?f=7&t=27373 |
Page 1 of 1 |
| Author: | mud_muncher [ Thu Nov 03, 2011 8:40 pm ] |
| Post subject: | Jimny Stuff: Body Lift, 3inch Springs, Gaurds. |
I Have some stuff lying around for people with Jimnys. The Body Lift could possible go on a sierra. What you see in the pic is what you get. (cept my tape measure Tough Dog 3inch Lift front Springs only, I used this but with the Bar and winch on it sagged to about 2inchs so could be good for someone with a 2inch lift with wieght on the front. Bit of surface rust but with a light sand and paint will look as good as new. $60 Pair. (might ship at your cost)
3inch Body lift with Steering spacer, bit rusted but with a sand and paint should be fine. Needs bolts though. A good cheap way to fit bigger tyres. $50 Plus Shipping (will ship)
3 Guards with rubber extenders, missing back right and some of the plastic mounts. Ditry but otherwise the paint is in ok nick. $30 each or $50 for all 3 (wont ship)
I am in Pakenham or Mulgrave on 0419308610 or PM Thanks, Harley |
|
| Author: | mud_muncher [ Sun Nov 06, 2011 8:06 am ] |
| Post subject: | Re: Jimny Stuff: Body Lift, 3inch Springs, Gaurds. |
Bump |
|
| Author: | mud_muncher [ Sun Nov 13, 2011 11:55 pm ] |
| Post subject: | Re: Jimny Stuff: Body Lift, 3inch Springs, Gaurds. |
Still for sale! Apparently you can use your stock front springs in the rear and these up front to give you a 3inch lift all around. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|