auszookers.com
http://auszookers.com/forum/

QLD- Vitara Parts - Bar Treads on 16s
http://auszookers.com/forum/viewtopic.php?f=7&t=47815		 Page 1 of 2
Author:  ozzycouch [ Tue Sep 16, 2014 8:47 pm ]
Post subject:  QLD- Vitara Parts - Bar Treads on 16s
Few things for sale off a 98 Model Vitara:

Bar Treads x4 - they come on skinny 16inch rims, which after scraping off some of the hand brushed green are young roh rims.
Tires are 16, 7.00 which measure a bit over 30 inch. They are retreads, which when I got them had never been driven on.
I've probably put 100km on them over a weekend of driving around. Not bad at all on the road.
Probably suit an earlier model zuk better than mine :rofl: - SOLD

FlexyGlass hard top, front and rear sections with key and fittings - SOLD
Sliders, suit 1-2" Body lift (Shown on car with 1" body lift, just touching the sills) - SOLD
Rear third member, 12 bolt 5.12 with auto locker (type that uses side gears) - SOLD
Rear aluminium roll hoop, suits soft top only - SOLD
Bull Bar - Aluminium, bit of a shunt in the front - $150 ono
Also have one SWB Virara Soft top which I'm wrecking, if you want any other bits PM me, might have them.

Pick up from Sunshine Coast
Author:  Tezzazook89 [ Wed Sep 17, 2014 6:23 am ]
Post subject:  Re: QLD - Vitara - Sliders, Roll Hoop, Fibre Glass Hard Top
What else you sell
Author:  ozzycouch [ Wed Sep 17, 2014 7:53 am ]
Post subject:  Re: QLD - Vitara - Sliders, Roll Hoop, Fibre Glass Hard Top
Post up what you want, then I can tell you if I have it and want to sell it.
Author:  David-mohr122 [ Wed Sep 17, 2014 12:58 pm ]
Post subject:  Re: QLD - Vitara - Sliders, Roll Hoop, Fibre Glass Hard Top
Bullbar ?
Author:  ozzycouch [ Wed Sep 17, 2014 2:35 pm ]
Post subject:  Re: QLD - Vitara - Sliders, Roll Hoop, Fibre Glass Hard Top
David-mohr122 wrote:
Bullbar ?


Bull Bar - Aluminium, bit of a shunt in the front

Image
Image
Image
Author:  David-mohr122 [ Wed Sep 17, 2014 2:38 pm ]
Post subject:  Re: QLD - Vitara - Sliders, Roll Hoop, Fibre Glass Hard Top
Can that accept a winch ? Haha sorry
Author:  ozzycouch [ Wed Sep 17, 2014 4:57 pm ]
Post subject:  Re: QLD - Vitara - Sliders, Roll Hoop, Fibre Glass Hard Top
Yes it would fit, 160mm inside clearance.
I would recomend reinforcing the bars mounting points before using a winch on it though. Just my 2c
Author:  Tezzazook89 [ Fri Sep 19, 2014 7:43 am ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
Can you use the rock sliders with no body lift
Author:  ozzycouch [ Fri Sep 19, 2014 9:37 am ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
Tezzazook89 wrote:
Can you use the rock sliders with no body lift

Short answer, NO.
Long answer, take them down to your local exhaust/ engineering shop, get them to put a couple of small bends in the connecting pipe to drop them lower off the sills, YES.
Author:  Vitvitara [ Tue Oct 28, 2014 9:44 am ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
Hi, any of that stuff still for sale?
Author:  ozzycouch [ Tue Oct 28, 2014 12:42 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
All but the sliders are still for sale, plenty of other stuff also.

And price drop on parts
Author:  Zuk_89 [ Wed Oct 29, 2014 2:50 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
How much for a shell with chassis?
Author:  ozzycouch [ Wed Oct 29, 2014 9:15 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
Zuk_89 wrote:
How much for a shell with chassis?

$200, Would recommend you come and have a look at what's left though.
Author:  Lyndon84 [ Thu Oct 30, 2014 9:15 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
Can see one is a manual any chance the other is a 3 speed auto?
Author:  ozzycouch [ Thu Oct 30, 2014 9:39 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
Sorry, both manual.
Author:  shandy92 [ Sat Nov 01, 2014 7:57 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
What condition are the gearbox's in? How many km?
Author:  ozzycouch [ Sun Nov 02, 2014 4:05 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
All noisy in 5th, and most over 300,000 km on them.
Author:  shandy92 [ Sun Nov 02, 2014 6:15 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
Ok, seems to be a common thing. Thanks
Author:  ozzycouch [ Sun Nov 02, 2014 7:42 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
I'll post up when I pull one down, I'm sick of the noisy fifth as well!
I'm sure there will only be a couple of bearings to get it quiet again.
Author:  shandy92 [ Sun Nov 02, 2014 9:30 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
Awesome, yep same as mine. I got 275k been a tiny bit whiney for the past 20k. If you could Let me know what you find that would be awesome.
Author:  vandle [ Mon Nov 03, 2014 12:31 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
Hi

How much for the fibreglass top and rear

cheers
Author:  ozzycouch [ Mon Nov 03, 2014 2:21 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
vandle wrote:
Hi
How much for the fibreglass top and rear
cheers

ozzycouch wrote:
FlexyGlass hard top, front and rear sections with key and fittings - $900 ono


However, always open to offers.
Author:  vandle [ Mon Nov 03, 2014 8:35 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
You have PM
Author:  TahneeMaree [ Wed Nov 05, 2014 5:56 pm ]
Post subject:  Re: QLD- Vitara Parts - Sliders, Roll Hoop, Fibre Glass Hard
Hi. Do you think the bullbar would fit my 2000 model vitara?
What part of the sunny coast are you at?
Could drive up to see if it would fit.
Author:  ozzycouch [ Wed Nov 05, 2014 8:06 pm ]
Post subject:  Re: QLD- Vitara Parts - Roll Hoop, Auto locker, Front Bar
Pretty sure your chassis is wider than the car it came off, so it won't fit without modifications.
Author:  brchalta [ Fri Nov 21, 2014 9:57 pm ]
Post subject:  Re: QLD- Vitara Parts - Roll Hoop, Auto locker, Front Bar
Hi do have locking hubs for a 1992 swb vitara.
Author:  ozzycouch [ Mon Nov 24, 2014 7:24 am ]
Post subject:  Re: QLD- Vitara Parts - Roll Hoop, Auto locker, Front Bar
brchalta wrote:
Hi do have locking hubs for a 1992 swb vitara.


Yep, got a pair here for $80
Author:  ozzycouch [ Mon Dec 08, 2014 10:23 am ]
Post subject:  Re: QLD- Vitara Parts - Bar Treads, Roll Hoop
Bump - Bar Treads Added
Author:  rockcrawlerdude [ Mon Dec 08, 2014 10:53 am ]
Post subject:  Re: QLD- Vitara Parts - Bar Treads, Roll Hoop
Still have the roll hoop?
Author:  ozzycouch [ Mon Dec 08, 2014 12:18 pm ]
Post subject:  Re: QLD- Vitara Parts - Bar Treads, Roll Hoop
rockcrawlerdude wrote:
Still have the roll hoop?


Sure do $50.00 if you buy it this week.
Page 1 of 2 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/