| auszookers.com http://auszookers.com/forum/ |
|
| rebuilt G13 with Weber 32/36 http://auszookers.com/forum/viewtopic.php?f=7&t=54981 |
Page 1 of 1 |
| Author: | Briesey [ Sun Jan 28, 2018 12:52 pm ] |
| Post subject: | rebuilt G13 with Weber 32/36 |
selling G13 out of 93 sierra with recently fully rebuilt bottom end. New pistons, rings and bearings. Head has been skimmed and valves lapped by hand, suspected valve guide issue as motor became smokey after extended idle. Also has ARP head studs and a weber 32/36 carburetor. Motor is without a sump due to it being involved in a Baleno conversion. Rebuilt bottom end has done roughly 10,xxx Km and I am selling as I have upgraded to a Baleno G16. Make an offer, was hoping to get around $600 for the lot, can request receipts from the engine builder if necessary. Located in Geelong Victoria. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|