| auszookers.com http://auszookers.com/forum/ |
|
| WTD - GV Rear Brake Drum http://auszookers.com/forum/viewtopic.php?f=8&t=21455 |
Page 1 of 1 |
| Author: | Mugwui [ Fri Apr 29, 2011 9:05 am ] |
| Post subject: | WTD - GV Rear Brake Drum |
After a single GV rear brake drum with a center diameter of 108mm. I've just tried to put mine back on the new axles to find the original 99 model drums have a centre diameter of 100mm, the new ones must be from a 2000 + model which apparently have a 108mm centre Diameter. |
|
| Author: | Built4thrashing [ Fri Apr 29, 2011 11:39 am ] |
| Post subject: | Re: WTD - GV Rear Brake Drum |
cant machine the ctr out? |
|
| Author: | Mugwui [ Fri Apr 29, 2011 12:18 pm ] |
| Post subject: | Re: WTD - GV Rear Brake Drum |
might be able too. have to have a look. |
|
| Author: | atari4x4 [ Fri Apr 29, 2011 12:20 pm ] |
| Post subject: | Re: WTD - GV Rear Brake Drum |
i have some drums off my SV, but i'd say they would be the 100mm bore ones, i'm at work but can have a look tomorrow |
|
| Author: | Mugwui [ Fri Apr 29, 2011 9:53 pm ] |
| Post subject: | Re: WTD - GV Rear Brake Drum |
There is enough there to machine...now to find someone to do it very quickly. |
|
| Author: | Built4thrashing [ Sat Apr 30, 2011 6:43 am ] |
| Post subject: | Re: WTD - GV Rear Brake Drum |
do a shep......use ya grinder |
|
| Author: | christover1 [ Sat Apr 30, 2011 7:03 am ] |
| Post subject: | Re: WTD - GV Rear Brake Drum |
Built4thrashing wrote: do a shep......use ya grinder
I used my grinder to machine down my hand brake drum, after doing disc conversion, cos it was just a nuisance getting caught on stuff. Worked ok fer a good many years. |
|
| Author: | atari4x4 [ Mon May 02, 2011 3:05 am ] |
| Post subject: | Re: WTD - GV Rear Brake Drum |
found mine, the SV420 has a 100mm diameter |
|
| Author: | Mugwui [ Mon May 02, 2011 7:32 am ] |
| Post subject: | Re: WTD - GV Rear Brake Drum |
Thanks for looking anyway. I'm hoping I may have found one but I won't know until tomorrow night. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|