| auszookers.com http://auszookers.com/forum/ |
|
| All sorted can delete thread http://auszookers.com/forum/viewtopic.php?f=8&t=53618 |
Page 1 of 1 |
| Author: | kemlar [ Tue Dec 06, 2016 5:55 pm ] |
| Post subject: | All sorted can delete thread |
After either buying or borrowing. It's for a 89 Vitara SWB. Need it by this weekend or next. Would buy one but need it quicker then post would this time of year. Located on the Sunshine coast. Any help is greatly appreciated. Joel |
|
| Author: | Bruce [ Tue Dec 06, 2016 6:09 pm ] |
| Post subject: | Re: Vitara/Jimny wheel bearing tool Sunshine coast QLD |
Buying one from here, you would get it in a few days. JMO |
|
| Author: | kemlar [ Tue Dec 06, 2016 7:42 pm ] |
| Post subject: | Re: Vitara/Jimny wheel bearing tool Sunshine coast QLD |
Where from? Only place comes from NZ? |
|
| Author: | Bruce [ Tue Dec 06, 2016 7:50 pm ] |
| Post subject: | Re: Vitara/Jimny wheel bearing tool Sunshine coast QLD |
Yep correct. He will post quickly. He's a good guy Ben. |
|
| Author: | shep [ Tue Dec 06, 2016 8:12 pm ] |
| Post subject: | Re: Vitara/Jimny wheel bearing tool Sunshine coast QLD |
I get stuff from him in around 5 days and I live in the middle of nowhere |
|
| Author: | kemlar [ Tue Dec 06, 2016 8:18 pm ] |
| Post subject: | Re: Vitara/Jimny wheel bearing tool Sunshine coast QLD |
I was hoping someone near me might have one. Would ultimately like it this weekend, only need to tighten the bearings, I need to use it for work next week. |
|
| Author: | kemlar [ Thu Dec 08, 2016 1:11 pm ] |
| Post subject: | Re: Vitara/Jimny wheel bearing tool Sunshine coast QLD |
I think I might have a go at making one out of pipe, nut, bolts, welding and grind to fit. |
|
| Author: | losfer [ Thu Dec 08, 2016 7:39 pm ] |
| Post subject: | Re: Vitara/Jimny wheel bearing tool Sunshine coast QLD |
So did you read my pm? |
|
| Author: | kemlar [ Thu Dec 08, 2016 8:13 pm ] |
| Post subject: | Re: Vitara/Jimny wheel bearing tool Sunshine coast QLD |
Yep thanks for the heads up, I sent a pm back. I ended up making a make shift one, today after work. Welds are a bit Dodgy, but worked fine. Saved some coin to using scrap from work. Moderators can delete this thread. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|