| auszookers.com http://auszookers.com/forum/ |
|
| LJ80 bumper dimensions or even better a bumper http://auszookers.com/forum/viewtopic.php?f=8&t=55183 |
Page 1 of 1 |
| Author: | Aircobra101 [ Fri May 11, 2018 8:35 pm ] |
| Post subject: | LJ80 bumper dimensions or even better a bumper |
i've been able source most of the parts, except for the bloody bumper then greg tells me that its just simple folded metal, so I'm hoping someone has one of these cars in melb so i can take measurements and have it made or a cardboard trace of the profile will do with a couple of phots thank you |
|
| Author: | Tommy21 [ Thu Jun 14, 2018 7:11 pm ] |
| Post subject: | Re: LJ80 bumper dimensions or even better a bumper |
Hey mate are u rafter measurements for a lj bumper or sierra here is some measurements of a lj bumper Length is 129cm Height 11cm Width of the top is 8cm Width of the bottom is 4cm The ends on the top are angled starting at the mounts to the end the end of the angle is 4cm Hope this can be of some use |
|
| Author: | Aircobra101 [ Fri Jun 15, 2018 9:22 pm ] |
| Post subject: | Re: LJ80 bumper dimensions or even better a bumper |
that's great, can't get the bastard anywhere. where are you located, i wouldn't mind a couple of photos ? |
|
| Author: | Tommy21 [ Fri Jun 15, 2018 9:29 pm ] |
| Post subject: | Re: LJ80 bumper dimensions or even better a bumper |
I’m located in orange NSW photos won’t upload at the moment will try again later |
|
| Author: | Tommy21 [ Fri Jun 15, 2018 9:43 pm ] |
| Post subject: | Re: LJ80 bumper dimensions or even better a bumper |
Ok so it’s saying photos are two big to upload any one know how to fix this or do u have a email or iMessage |
|
| Author: | sideways [ Fri Jun 15, 2018 9:57 pm ] |
| Post subject: | Re: LJ80 bumper dimensions or even better a bumper |
The stock bumper is made out of sheet metal and is quite flimsy. I've never seen one that wasn't bent or dented. Personally I plan to replace mine with a thicker one made from RHS with a radius welded on each end, basically like a series Land Rover bumper. |
|
| Author: | Tommy21 [ Sat Jun 16, 2018 6:45 am ] |
| Post subject: | Re: LJ80 bumper dimensions or even better a bumper |
Must be lucky mines perfectly straight my hole Ute was prtiy good the fella looked after it apparently |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|